[U-Boot-Users] RJ45 pinout of SBC8260

[Chuck Gales <cgales@gmail.com>]

According to the SBC8260 manual, there are two serial ports (JP13 &
JP14), but they are RJ-11 ports, not RJ-45.

The pinouts for both are:
Pin 1 - RXDA
Pin 2 - TXDA
Pin 3 - N/C
Pin 4 - Ground

Chuck

On Mon, 08 Nov 2004 22:37:21 +0100, Wolfgang Denk <wd@denx.de> wrote:
> In message <3c09ea2e0411081309a356019@mail.gmail.com> you wrote:
> >
> > http://www.bsicomputer.com/ftp/pdf/sbc8260.pdf
> 
> No. It's this one:
> http://www.windriver.com/japan/products/files/ppc_sbc8260.pdf
> 
> > > I plan to load u-boot to a sbc8260 board. There is no
> > > document available for this board. Any one has
> 
> I have to  admit  that  it  was  extremely  difficult  to  find  this
> document. It turned up as position one when I googled for "sbc8260".
> 
> I don't dare to mention that searching for "sbc8260" at
> http://www.windriver.com/ even turns up more information...
> 
> Best regards,
> 
> Wolfgang Denk
> 
> --
> See us @ Embedded/Electronica Munich, Nov 09 - 12, Hall A.6 Booth 513
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> I don't know if it's what you want, but it's what you get.  :-)
>                       - Larry Wall in <10502@jpl-devvax.JPL.NASA.GOV>
>