Re: [PATCH 2/8] Add uli1575 pci-bridge sector to MPC8641HPCN dts file.

[Segher Boessenkool <segher@kernel.crashing.org>]

>>>>> +						i8259: i8259@4d0 {
>>>>
>>>> Needs "reg".  And 4d0 isn't the primary address
>>>> I think?
>>>
>>> Yes, this is a standard i8259 with additional registers at 0x20 and
>>> 0xa0.  I'll fix the address and add the registers.
>>
>> That sounds good, thanks!
>
> I'd beg to differ. There are three registers area:
>
> - 0x20 which is the master interrupt controller
>   (since the original 1981 IBM-PC)
> - 0xa0 which is the slave interrupt controller, connected to
>   IRQ2 of the master (introduced with the XT or the AT, I don't
>   remember)
> - 0x4d0 which was added later to allow per interrupt line setting
>   of edge or level triggering (instead of per controller).
>
> By far the most important registers are the ones at 0x20 since
> you access them at every interrupt. The registers at 0x4d0
> are typically set by firmware and never touched later, there
> is not a single access to them in sysdev/i8259.c.

Yes, I think we all agree -- it should be interrupt-controller@20,
with 20, a0, 4d0 in the "reg" property.

I'm not sure what "compatible" should be for this node, someone
else can dig that up :-)


Segher