All of lore.kernel.org
 help / color / mirror / Atom feed
From: Sid Boyce <sboyce@blueyonder.co.uk>
To: linux-kernel@vger.kernel.org
Subject: Re: 2.6.5-rc3-mm4
Date: Sat, 03 Apr 2004 12:08:13 +0100	[thread overview]
Message-ID: <406E9B1D.7070201@blueyonder.co.uk> (raw)
In-Reply-To: <406CD984.2010200@blueyonder.co.uk>

Sid Boyce wrote:

> My x86_64 Acer 1501LCe laptop problem persists, it freezes at the same 
> point with the HD light on solid. Boot proceeds normally up to "found 
> reiserfs format "3.6" with standard journal".
> Regards
> Sid.
>
Tried using netconsole, but no network traffic, suppose because the 
network is not yet up, so I can't get a call trace captured with ...
netconsole=6665@192.168.10.5/eth0,6666@192.168.10.1/00:40:95:30:db:5b

 From SysRq-B
============
Uniform CD-ROM driver Revision: 3.20
mice: PS/2 mouse device common for all mice
input: PC Speaker
i8042.c: Detected active multiplexing controller, rev 1.1.
serio: i8042 AUX0 port at 0x60,0x64 irq 12
serio: i8042 AUX1 port at 0x60,0x64 irq 12
serio: i8042 AUX2 port at 0x60,0x64 irq 12
serio: i8042 AUX3 port at 0x60,0x64 irq 12
Synaptics Touchpad, model: 1
Firmware: 5.8
180 degree mounted touchpad
Sensor: 18
new absolute packet format
Touchpad has extended capability bits
-> 4 multi-buttons, i.e besides standard buttons
-> multifinger detection
-> palm detection
input: SynPS/2 Synaptics TouchPad on isa0060/serio4
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
NET: Registered protocol family 2
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 32768)
Net: Registered protocol family 1
ACPI: (supports S0 S3 S4 S5)
found reiserfs format "3.6" with standard journal
SysRq: Show Regs

Pid: 0, comm: swapper Not tainted 2.6.5-rc3-mm4
RIP: 0010:[<ffffffff8010e660>] <ffffffff80103660>{default_idle+32}
RSP: 0000:ffffffff8050ffc8  EFLAGS: 00000246
RAX: 0000000000000000 RBX: ffffffff8010e640 RCX: ffffffff8040ca40
RDX: 0000000000000000 RSI: 00000000ffffffff RDI: 000001001fe86040
RBP: 0000000000000000 R08: ffffffff8050e000 R09: 00000000ffffffff
R10: 0000000000000000 R11: 00000000ad55ad55 R12: 0000000000000000
R13: 0000000000000000 R14: 0000000000000000 R15: 0000000000000000
FS:  0000000000000000(0000) GS:ffffffff80507800(0000) knlGS:0000000000000000
CS:  0010 DS: 0018 ES: 0018 CR0: 000000008005003b
CR2: 0000000000000000 CR3: 0000000000101000 CR4: 00000000000006e0

Call Trace:<ffffffff8010f5da>{cpu_idle+26} 
<ffffffff805117ad>{start_kernel+509}
       <ffffffff805110e5>{__init_begin+229}
Regards
Sid.

-- 
Sid Boyce .... Hamradio G3VBV and keen Flyer
Linux Only Shop.


  reply	other threads:[~2004-04-03 11:06 UTC|newest]

Thread overview: 20+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2004-04-02  3:09 2.6.5-rc3-mm4 Sid Boyce
2004-04-03 11:08 ` Sid Boyce [this message]
2004-04-04 22:32   ` 2.6.5 x86_64 still broken - was 2.6.5-rc3-mm4 Sid Boyce
  -- strict thread matches above, loose matches on Subject: below --
2004-04-04  1:15 2.6.5-rc3-mm4 Paul Blazejowski
2004-04-04 23:34 ` 2.6.5-rc3-mm4 Trond Myklebust
2004-04-05  1:25   ` 2.6.5-rc3-mm4 Paul Blazejowski
2004-04-01 10:05 2.6.5-rc3-mm4 Andrew Morton
2004-04-01 12:02 ` 2.6.5-rc3-mm4 Marc-Christian Petersen
2004-04-01 15:16   ` 2.6.5-rc3-mm4 Greg KH
2004-04-01 15:32     ` 2.6.5-rc3-mm4 Marc-Christian Petersen
2004-04-01 14:12 ` 2.6.5-rc3-mm4 Norberto Bensa
2004-04-02  1:35   ` 2.6.5-rc3-mm4 Joshua Kwan
2004-04-02  2:09     ` 2.6.5-rc3-mm4 Norberto Bensa
2004-04-02 19:04 ` 2.6.5-rc3-mm4 markw
2004-04-02 19:56   ` 2.6.5-rc3-mm4 Andrew Morton
2004-04-02 20:46     ` 2.6.5-rc3-mm4 markw
2004-04-02 23:43     ` 2.6.5-rc3-mm4 Nick Piggin
2004-04-03  0:10       ` 2.6.5-rc3-mm4 Mark Wong
2004-04-03  0:12         ` 2.6.5-rc3-mm4 Nick Piggin
2004-04-06 15:20           ` 2.6.5-rc3-mm4 markw

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=406E9B1D.7070201@blueyonder.co.uk \
    --to=sboyce@blueyonder.co.uk \
    --cc=linux-kernel@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.