From: Thomas Babut <thomas@babut.net>
To: linux-scsi@vger.kernel.org
Cc: Matthew Wilcox <matthew@wil.cx>
Subject: Re: Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter
Date: Fri, 19 Nov 2004 10:32:40 +0100 [thread overview]
Message-ID: <419DBDB8.2010805@babut.net> (raw)
In-Reply-To: <1099928314.10944.81.camel@compaq-rhel4.xsintricity.com>
Hi all,
yesterday I tried some new Kernels...
2.4.28-bk1 with sym53c8xx: works with normal Performance
Bootlog:
Nov 19 01:31:39 srv kernel: SCSI subsystem driver Revision: 1.00
Nov 19 01:31:39 srv kernel: sym53c8xx: at PCI bus 0, device 8, function 0
Nov 19 01:31:39 srv kernel: sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
Nov 19 01:31:39 srv kernel: sym53c8xx: 53c1010-33 detected with Symbios
NVRAM
Nov 19 01:31:39 srv kernel: sym53c8xx: at PCI bus 0, device 8, function 1
Nov 19 01:31:39 srv kernel: sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
Nov 19 01:31:39 srv kernel: sym53c8xx: 53c1010-33 detected with Symbios
NVRAM
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: rev 0x1 on pci bus 0 device
8 function 0 irq 9
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: Symbios format NVRAM, ID 7,
Fast-80, Parity Checking
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: on-chip RAM at 0xf9000000
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: restart (scsi reset).
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: handling phase mismatch
from SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: Downloading SCSI SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: rev 0x1 on pci bus 0 device
8 function 1 irq 11
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: Symbios format NVRAM, ID 7,
Fast-80, Parity Checking
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: on-chip RAM at 0xf8000000
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: restart (scsi reset).
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: handling phase mismatch
from SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: Downloading SCSI SCRIPTS.
Nov 19 01:31:39 srv kernel: scsi0 : sym53c8xx-1.7.3c-20010512
Nov 19 01:31:39 srv kernel: scsi1 : sym53c8xx-1.7.3c-20010512
Nov 19 01:31:39 srv kernel: blk: queue f7e9a018, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:31:39 srv kernel: Vendor: QUANTUM Model: ATLAS10K2-TY367J
Rev: DDD6
Nov 19 01:31:39 srv kernel: Type: Direct-Access
ANSI SCSI revision: 03
Nov 19 01:31:39 srv kernel: blk: queue f7e67e18, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:31:39 srv kernel: sym53c1010-33-0-<2,0>: tagged command queue
depth set to 8
Nov 19 01:31:39 srv kernel: Attached scsi disk sda at scsi0, channel 0,
id 2, lun 0
Nov 19 01:31:39 srv kernel: sym53c1010-33-0-<2,*>: FAST-40 SCSI 40.0
MB/s (25.0 ns, offset 31)
Nov 19 01:31:39 srv kernel: SCSI device sda: 71721820 512-byte hdwr
sectors (36722 MB)
Nov 19 01:31:39 srv kernel: Partition check:
Nov 19 01:31:39 srv kernel: sda: sda1 sda2
2.4.28-bk1 with sym53c8xx2: works, but poor performance (max. 5 MByte/s)
Bootlog:
Nov 19 01:27:19 srv kernel: SCSI subsystem driver Revision: 1.00
Nov 19 01:27:19 srv kernel: sym.0.8.0: setting PCI_COMMAND_PARITY...
Nov 19 01:27:19 srv kernel: sym.0.8.1: setting PCI_COMMAND_PARITY...
Nov 19 01:27:19 srv kernel: sym0: <1010-33> rev 0x1 on pci bus 0 device
8 function 0 irq 9
Nov 19 01:27:19 srv kernel: sym0: using 64 bit DMA addressing
Nov 19 01:27:19 srv kernel: sym0: Symbios NVRAM, ID 7, Fast-80, LVD,
parity checking
Nov 19 01:27:19 srv kernel: sym0: open drain IRQ line driver, using
on-chip SRAM
Nov 19 01:27:19 srv kernel: sym0: using LOAD/STORE-based firmware.
Nov 19 01:27:19 srv kernel: sym0: handling phase mismatch from SCRIPTS.
Nov 19 01:27:19 srv kernel: sym0: SCSI BUS has been reset.
Nov 19 01:27:19 srv kernel: sym1: <1010-33> rev 0x1 on pci bus 0 device
8 function 1 irq 11
Nov 19 01:27:19 srv kernel: sym1: using 64 bit DMA addressing
Nov 19 01:27:19 srv kernel: sym1: Symbios NVRAM, ID 7, Fast-80, LVD,
parity checking
Nov 19 01:27:19 srv kernel: sym1: open drain IRQ line driver, using
on-chip SRAM
Nov 19 01:27:19 srv kernel: sym1: using LOAD/STORE-based firmware.
Nov 19 01:27:19 srv kernel: sym1: handling phase mismatch from SCRIPTS.
Nov 19 01:27:19 srv kernel: sym1: SCSI BUS has been reset.
Nov 19 01:27:19 srv kernel: scsi0 : sym-2.1.17a
Nov 19 01:27:19 srv kernel: scsi1 : sym-2.1.17a
Nov 19 01:27:19 srv kernel: blk: queue f7e9a018, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:27:19 srv kernel: Vendor: QUANTUM Model: ATLAS10K2-TY367J
Rev: DDD6
Nov 19 01:27:19 srv kernel: Type: Direct-Access
ANSI SCSI revision: 03
Nov 19 01:27:19 srv kernel: blk: queue f7e64e18, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:27:19 srv kernel: sym0:2:0: tagged command queuing enabled,
command queue depth 16.
Nov 19 01:27:19 srv kernel: Attached scsi disk sda at scsi0, channel 0,
id 2, lun 0
Nov 19 01:27:19 srv kernel: sym0:2:0:M_REJECT to send for : 1-3-1-9-1f.
Nov 19 01:27:19 srv kernel: SCSI device sda: 71721820 512-byte hdwr
sectors (36722 MB)
Nov 19 01:27:19 srv kernel: Partition check:
Nov 19 01:27:19 srv kernel: sda: sda1 sda2
2.6.10-rc2-bk3 with sym53c8xx2: System doesn't come up, same errors as
before
No bootlog because of the lack of physical access to the machine.
I still would like to run Kernel 2.6. :)
Regards,
Thomas Babut
next prev parent reply other threads:[~2004-11-19 9:32 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-11-05 16:25 Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Ada pter SUPPORT
2004-11-05 17:01 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter Tony Battersby
2004-11-05 18:07 ` Matthew Wilcox
2004-11-05 20:36 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Ada pter Matthew Wilcox
2004-11-05 23:44 ` Thomas Babut
2004-11-06 4:20 ` Doug Ledford
2004-11-08 14:44 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter Tony Battersby
2004-11-08 15:38 ` Doug Ledford
2004-11-19 9:32 ` Thomas Babut [this message]
2004-11-23 1:39 ` Thomas Babut
2004-11-23 1:40 ` Matthew Wilcox
2004-11-27 19:52 ` Ingo Korb
-- strict thread matches above, loose matches on Subject: below --
2005-02-09 19:25 Thomas Babut
2004-11-05 16:07 Thomas Babut
2004-11-05 17:29 ` Tony Battersby
2004-11-05 12:52 Thomas Babut
2004-11-05 13:43 ` Matthew Wilcox
2004-11-05 13:59 ` Thomas Babut
2004-11-05 14:19 ` Matthew Wilcox
2004-11-05 14:27 ` Thomas Babut
2004-11-04 2:04 Thomas Babut
2004-11-04 2:57 ` George Glover
2004-11-04 2:59 ` Thomas Babut
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=419DBDB8.2010805@babut.net \
--to=thomas@babut.net \
--cc=linux-scsi@vger.kernel.org \
--cc=matthew@wil.cx \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.