Evgeniy Zaitsev schrieb:
> Hello, Lopsch.
> 
> Sunday, December 5, 2004, 6:19:55 PM, you wrote:
> 
> 
>>>I try to use latest patch-o-matic to
>>>I have tried to use last patch-o-matic
>>>(patch-o-matic-ng-20040621.tar.bz2 also do not work)
>>>for addition of purpose CONNMARK in iptables on a kernel 2.6.9
>>>
>>>But the patch is not set, as does not find the necessary lines of a code in a file
>>>linux/net/ipv4/netfilter/ip_conntrack_standalone.c
>>>
> 
> L> Try this:
> 
> Thanks, Lopsch, patch are works. It appears, for its imposing it was
> necessary to take advantage switcg "-F 3", As with "-F 2 " don't
> passed any chunks.
> 
> Unfortunately, I have faced the same problem, as with previous a patch (patch-o-matic-ng-20040621)
> on a kernel 2.6.7
> 
> iptables -t mangle -A PREROUTING -i eth1 -j prert_services_ctv_spec_ctv
> iptables -t mangle -A prert_services_ctv_spec_ctv -s 10.0.0.0/8 -m mac --mac-source 00:90:27:A7:58:21 -m
> state --state NEW -j CONNMARK --set-mark 0x40 
> iptables -t mangle -A prert_services_ctv_spec_ctv -m mark --mark 0x40 -j ACCEPT 
> iptables -t mangle -A prert_services_ctv_spec_ctv -s 10.0.0.0/8 -m state --state NEW -j CONNMARK
> --set-mark 0x60 
> iptables -t mangle -A prert_services_ctv_spec_ctv -m mark --mark 0x60 -j ACCEPT 
> 
> In this rules list a command
> iptables-t mangle-A prert_services_ctv_spec_ctv-m mark - mark 0x40-j ACCEPT 
> does not work:
> 
> # iptables -t mangle -nxvL  prert_services_ctv_spec_ctv
> Chain prert_services_ctv_spec_ctv (1 references)
>     pkts      bytes target     prot opt in     out     source               destination
>        5      304 CONNMARK   all  --  *      *       10.0.0.0/8           0.0.0.0/0           MAC
> 00:90:27:A7:58:21 state NEW CONNMARK set 0x40
>        0        0 ACCEPT     all  --  *      *       0.0.0.0/0            0.0.0.0/0           MARK match
> 0x40
>      116     6048 CONNMARK   all  --  *      *       10.0.0.0/8           0.0.0.0/0           state NEW
> CONNMARK set 0x60
>    57464 48953156 ACCEPT     all  --  *      *       0.0.0.0/0            0.0.0.0/0           MARK match
> 0x60
> 
> 
> This commands used for "not simple routing":
> 
>                                       ----- router1 ---\
>     LAN1            LAN1-router,NAT  / mark 0x40        \
> 192.168.1.0/24 ---> 192.168.1.1(eth1)                      LAN2 10.0.0.0/8
>                                      \ mark 0x60        /
>                                       ----- router2 ---/
> 
> 
> LAN2, 10.0.0.0/24 it is possible to enter two different ways, through
> router1 with mac addr 00:90:27:A7:58:21 and through router2.
> 
> Inside LAN1 are a servers which from LAN2 are visible under different
> IP-addresses (router1 and router2 addresses).
> Therefore it is necessary  what the inquiry coming through router1 in
> LAN1, back came back as through router1. For router2 - it is similar.
> 
> For this purpose I marking incoming connections (from LAN2) in a chain
> "prert_services_ctv_spec_ctv" (*mangle table) and when packets on this connection come back in LAN2,
> they depending on marks (I apply - restore-mark) on the same channel on whom they and came.
> 
> But the matter is that a command
> iptables-t mangle-A prert_services_ctv_spec_ctv-m mark - mark 0x40-j ACCEPT 
> does not work, therefore all entering connections are marked as 0x60
> and are sent through router2 :(
> 
> I where that was mistaken in a spelling of rules?
> I can not understand in any way. Thought, switching to kernel 2.6.9 will rescue, appeared - has not
> rescued.
> 
> 
> 
> 
Sorry I canīt help, because I donīt understand what youīre trying to 
explain and the topology of that network :(.

-- 

PGP-ID 0xF8EAF138