Re: [LARTC] Load Balance Outbound AND Inbound Internet Traffic to

[Andy Furniss <andy.furniss@dsl.pipex.com>]

Joe Nuts wrote:
> I have boxes at both ends of the link. I have spent my whole day
> searching the internet on anything to do with 'multilink ppp', and
> have not found any decent documentation on how to set something like
> that up. perhaps somone could point me to something?

I am not sure about setting up a server, but there must be a few 
examples of client setups around for ISDN. Here is one for DSL

http://www.freestuffjunction.co.uk/bondedadsl.shtml


> As for the setup, server at the ISP has one public IP A, on public
> network A. it receives/routes traffic for public network B.
> the server at the client site has two public IP's, X and Y on public
> network X and Y.
> I would like for traffic sent to public network B to make it to client
> computer, divided across the two IP's X, and Y. (this traffic will of
> course go through server at the ISP, which will do the work in
> splitting the traffic up)

You probably know more advanced routing than me - I have never played 
about with complicated setups. As far as using ppp  - I don't think you 
have to worry about IP addresses too much - it's link level, so I think 
you can send whatever you like down it and it will appear at the other end.

Andy.

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/