Re: data_xfer too fast? - SATA PIO

[Mark Lord <liml@rtr.ca>]

Err.. PIO data transfer within a sector (or multiple sector block)
is supposed to be synchronous in hardware.  This means the chip/board
should be using IORDY to stretch the cycle until data can be supplied
within each 256-word interrupt group.

Right?

Mat Loikkanen wrote:
> We've run into the issue of ata_mmio_data_xfer() reading our host
> controller's data fifo too fast -- requesting a data word when the fifo was
> empty, before the device had sent PIO data (in our observed case somewhere
> in the middle of a 512 byte IDENTIFY DEVICE PIO data transfer).  I can't see
> any provision in Libata for a case like ours where the processor and bus are
> "too fast".  Has anyone run into this issue before?  Any ideas on what we
> should do about it?  We can make our host controller to wait-state the bus
> ... but for how long, what if data never arrives ...  Thanks for any help.
> 
> -mat
>  
> Mat Loikkanen
> Synopsys, Inc.