mpc8560ads PCI bus

[Greg Weeks <greg.weeks@timesys.com>]

Has anyone else tried to get the PCI bus working on the mpc8560ads board 
at 2.6.11? The card enumerates, but the I/O resource regions aren't 
getting set up.

-bash-2.05b# lspci -vv
00:03.0 Unknown mass storage controller: Silicon Image, Inc. (formerly 
CMD Technology Inc) PCI0680 Ultra ATA-133 Host Controller (rev 02)
        Subsystem: Silicon Image, Inc. (formerly CMD Technology Inc) 
PCI0680 Ultra ATA-133 Host Controller
        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR+
        Interrupt: pin A routed to IRQ 100
        Region 0: I/O ports at <unassigned> [disabled]
        Region 1: I/O ports at <unassigned> [disabled]
        Region 2: I/O ports at <unassigned> [disabled]
        Region 3: I/O ports at <unassigned> [disabled]
        Region 4: I/O ports at <unassigned> [disabled]
        Capabilities: [60] Power Management version 2
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA 
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=2 PME-
 
Greg Weeks