From: Michael Krufky <mkrufky@m1k.net>
To: Andrew Morton <akpm@osdl.org>
Cc: linux-kernel@vger.kernel.org, Hugh Dickins <hugh@veritas.com>
Subject: Re: 2.6.15-rc1-mm2
Date: Fri, 18 Nov 2005 11:29:26 -0500 [thread overview]
Message-ID: <437E0166.3000208@m1k.net> (raw)
In-Reply-To: <20051117234645.4128c664.akpm@osdl.org>
Andrew Morton wrote:
>ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.15-rc1/2.6.15-rc1-mm2/
>
>
>- I'm releasing this so that Hugh's MM rework can get a spin.
>
> Anyone who had post-2.6.14 problems related to the VM_RESERVED changes
> (device drivers malfunctioning, obscure userspace hardware-poking
> applications stopped working, etc) please test.
>
I gave it a quick test before leaving the house this morning... Here is
an exerp from an oops I got after closing mplayer, watching an ATSC (dvb
in USA) stream, using AverTVHD a180 (saa7134 + nxt200x).
[snip]
Bad page state at free_hot_cold_page (in process 'mplayer', page c15c03e0)
flags:0x80000414 mapping:00000000 mapcount:0 count:0
Backtrace:
[<c0103b53>] dump_stack+0x16/0x1a
[<c0134db9>] bad_page+0x5f/0xe9
[<c0135519>] free_hot_cold_page+0x58/0xf7
[<c01355c2>] free_hot_page+0xa/0xc
[<c0138367>] __page_cache_release+0xab/0xb0
[<c0137fe0>] put_page+0x5c/0x5e
[<c01428d7>] free_page_and_swap_cache+0x2c/0x32
[<c013bd02>] zap_pte_range+0x1b1/0x249
[<c013be5f>] unmap_page_range+0xc5/0xd6
[<c013bf10>] unmap_vmas+0xa0/0x171
[<c013f73c>] unmap_region+0x76/0xf2
[<c013f9c8>] do_munmap+0xdd/0x100
[<c013fa25>] sys_munmap+0x3a/0x56
[<c0102d05>] syscall_call+0x7/0xb
---------------------------
| preempt count: 00000002 ]
| 2 level deep critical section nesting:
----------------------------------------
.. [<c013bf92>] .... unmap_vmas+0x122/0x171
.....[<c013f73c>] .. ( <= unmap_region+0x76/0xf2)
.. [<c013bb89>] .... zap_pte_range+0x38/0x249
.....[<c013be5f>] .. ( <= unmap_page_range+0xc5/0xd6)
Hexdump:
000: 04 04 00 80 ff ff ff ff ff ff ff ff 00 00 00 00
010: 00 00 00 00 00 00 00 00 b8 03 5c c1 b8 03 5c c1
020: 04 04 00 80 ff ff ff ff ff ff ff ff 00 00 00 00
030: 00 00 00 00 00 00 00 00 d8 03 5c c1 d8 03 5c c1
040: 14 04 00 80 ff ff ff ff ff ff ff ff 00 00 00 00
050: 00 00 00 00 00 00 00 00 f8 03 5c c1 f8 03 5c c1
060: 00 04 00 80 00 00 00 00 ff ff ff ff 00 00 00 00
070: 00 00 00 00 00 00 00 00 00 01 10 00 00 02 20 00
080: 00 04 00 80 ff ff ff ff ff ff ff ff 00 00 00 00
090: 00 00 00 00 00 00 00 00 38 04 5c c1 38 04 5c c1
0a0: 00 04 00 80 ff ff ff ff ff ff ff ff 00 00 00 00
0b0: 00 00 00 00 00 00 00 00 58 04 5c c1 58 04 5c c1
Trying to fix it up, but a reboot is needed
[snip]
More detailed log at:
http://techsounds.org/v4l/2.6.15-rc1-mm2-error.log
The oops spammed the entire log, so if you need to see what I have
running on my system, here is a working dmesg (only v4l+dvb parts) from
2.6.14 + hybrid (v4l+dvb) merged cvs, almost equivalent code to what we
have in the current kernel:
http://techsounds.orgdotorg.org/v4l/dmesg.txt
I understand that you might need some more info.... Email me if you need
something else... I'll be around for the next 5 hours.... After that, I
will be away for the weekend, and I can do more tests on Monday
evening. This was on an intel p4, 2.53 GHz, 533 FSB, 768 MB ram, using
Intel D845PEBT2 motherboard.
-Michael Krufky
--
Michael Krufky
next prev parent reply other threads:[~2005-11-18 16:29 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2005-11-09 13:49 [PATCH 00/16] Adaptive read-ahead V7 Wu Fengguang
2005-11-09 13:49 ` [PATCH 01/16] mm: delayed page activation Wu Fengguang
2005-11-10 0:21 ` Nick Piggin
2005-11-10 3:15 ` Wu Fengguang
2005-11-10 9:17 ` Peter Zijlstra
2005-11-10 10:30 ` Wu Fengguang
2005-11-09 13:49 ` [PATCH 02/16] mm: balance page aging between zones Wu Fengguang
2005-11-09 13:49 ` [PATCH 03/16] radixtree: sync with mainline Wu Fengguang
2005-11-09 13:49 ` [PATCH 04/16] radix-tree: look-aside cache Wu Fengguang
2005-11-09 23:31 ` Nick Piggin
2005-11-10 5:25 ` Wu Fengguang
2005-11-10 6:50 ` Nick Piggin
2005-11-10 8:30 ` Wu Fengguang
2005-11-18 11:25 ` Wu Fengguang
2005-11-18 12:12 ` Wu Fengguang
2005-11-09 13:49 ` [PATCH 05/16] readahead: some preparation Wu Fengguang
2005-11-18 7:46 ` 2.6.15-rc1-mm2 Andrew Morton
2005-11-18 8:56 ` 2.6.15-rc1-mm2 Benoit Boissinot
2005-11-18 9:04 ` 2.6.15-rc1-mm2 Andrew Morton
2005-11-18 9:13 ` 2.6.15-rc1-mm2 Benoit Boissinot
2005-11-18 13:43 ` 2.6.15-rc1-mm2 Rafael J. Wysocki
2005-11-18 10:10 ` 2.6.15-rc1-mm2 Mauro Carvalho Chehab
2005-11-18 10:55 ` 2.6.15-rc1-mm2 Wu Fengguang
2005-11-18 11:29 ` 2.6.15-rc1-mm2 Andy Whitcroft
2005-11-18 16:29 ` Michael Krufky [this message]
2005-11-20 0:23 ` 2.6.15-rc1-mm2 Michal Piotrowski
2005-11-20 8:04 ` 2.6.15-rc1-mm2 Hugh Dickins
2005-11-20 12:53 ` 2.6.15-rc1-mm2 Michal Piotrowski
2005-11-09 13:49 ` [PATCH 06/16] readahead: call scheme Wu Fengguang
2005-11-09 13:49 ` [PATCH 07/16] readahead: tunable parameters Wu Fengguang
2005-11-09 13:49 ` [PATCH 08/16] readahead: state based method Wu Fengguang
2005-11-09 13:49 ` [PATCH 09/16] readahead: context " Wu Fengguang
2005-11-09 13:49 ` [PATCH 10/16] readahead: other methods Wu Fengguang
2005-11-09 13:49 ` [PATCH 11/16] readahead: mandatory thrashing protection Wu Fengguang
2005-11-09 13:49 ` [PATCH 12/16] readahead: events accounting Wu Fengguang
2005-11-09 13:49 ` [PATCH 13/16] readahead: page aging accounting Wu Fengguang
2005-11-09 13:49 ` [PATCH 14/16] readahead: laptop mode support Wu Fengguang
2005-11-09 13:49 ` [PATCH 15/16] readahead: disable look-ahead for loopback file Wu Fengguang
2005-11-09 13:49 ` [PATCH 16/16] io: reduce lantency Wu Fengguang
2005-11-09 20:39 ` [PATCH 00/16] Adaptive read-ahead V7 Christoph Lameter
2005-11-10 10:19 ` Wu Fengguang
-- strict thread matches above, loose matches on Subject: below --
2005-11-18 7:46 2.6.15-rc1-mm2 Andrew Morton
2005-11-18 19:36 2.6.15-rc1-mm2 Steve French
2005-11-19 16:14 2.6.15-rc1-mm2 Stas Sergeev
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=437E0166.3000208@m1k.net \
--to=mkrufky@m1k.net \
--cc=akpm@osdl.org \
--cc=hugh@veritas.com \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.