From mboxrd@z Thu Jan 1 00:00:00 1970 From: gypsy Date: Wed, 21 Dec 2005 04:50:31 +0000 Subject: Re: [LARTC] Advanced Routing and Secondary ip address in eth0 Message-Id: <43A8DF17.FC4B1060@iswest.com> List-Id: References: <43A85B7A.90808@netwall.com.br> In-Reply-To: <43A85B7A.90808@netwall.com.br> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Leonardo Borda wrote: > > Hello, > > I have configured advanced routing with success using three (03) > network adapters ( ETH0, ETH1 and ETH2). > Now I have to configure an addittion range in the same Interface > ETH0 ( another internet ip range address ), so I would like to have TWO > different ranges at the same ETHERNET CARD ( in this case ETH0 ) AND > having advanced routing running it. > I Did the same configurations as I already done it before and it is > not working. When testing through the secondary ip address the packets > get out from the wrong default gateway, however testing from primary > range I am able to route. > > Is it possible to do advanced routing having in the same Interface > TWO different ip range address? > > Somebody had done this somewhere? > > Thanks in advanced > > -- > Atenciosamente, > > Leonardo Borda Leonardo, Have you Yahooed/googled this? IIRC, I came across several pages describing your desired setup while trying to decide how to deal with 3 NICs and two different IPS (therefore separate nets on each NIC). Again IIRC, I rejected these because they were not the correct solution for me. Sorry I can't be more help, but I do think your solution is "out there". -- gypsy _______________________________________________ LARTC mailing list LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc