Re: [PATCH v2 00/18] Add DT support for CSI2RX multi-stream

[Krzysztof Kozlowski <krzk@kernel.org>]

On 26/08/2026 07:46, Rishikesh Donadkar wrote:
> 
> 
> On 13/07/26 17:04, Yemike Abhilash Chandra wrote:
>> Support for multi-stream in j721e-csi2rx.c driver was merged last cycle[0].
>> This series adds the corresponding device tree support.
>>
>> Patch 1 is a cleanup fixing indentation in the existing CSI2RX nodes.
>>
>> The next few patches i.e. (Patch 2 to Patch 6) add the additional DMA
>> channels required for CSI2RX multi-stream capture.
>>
>> Multi-stream capture uses a SERDES pair based on the FPD-Link or
>> V3Link protocol. The serializer takes the input from a camera sensor
>> and converts it to the FPD-Link standard, while the deserializer
>> aggregates streams from multiple serializers and sends them over the
>> CSI-2 RX interface. Each CSI2RX instance therefore indirectly receives
>> input from multiple sensors.
>>
>> The remaining patches add overlays for various deserializer boards,
>> and for the UB953 serializer with the IMX219 sensor. Also enabling
>> DS90UB960 deserializer and DS90UB953 serializer drivers in the
>> arm64 defconfig.
> 
> Hi Abhilash,
> 
> Thank you for the series. LGTM !
> 
> For the entire series,
> 
> Reviewed-by: Rishikesh Donadkar <r-donadkar@ti.com>

You did not have comments for v1, no comments here, so are you really
reviewed it (considering code has obvious issues)?

Best regards,
Krzysztof