[patch 3/4] myri10ge - Use dev_info() when printing parameters after probe

[Brice Goglin <brice@myri.com>]

Displaying the interface name when listing the device parameters
at the end of myri10ge_probe is not a good idea since udev might
rename the interface soon afterwards.
Print the bus id instead, using dev_info().

Signed-off-by: Brice Goglin <brice@myri.com>
---
 drivers/net/myri10ge/myri10ge.c |    9 ++++-----
 1 file changed, 4 insertions(+), 5 deletions(-)

Index: linux-mm/drivers/net/myri10ge/myri10ge.c
===================================================================
--- linux-mm.orig/drivers/net/myri10ge/myri10ge.c	2006-07-03 16:02:52.000000000 -0400
+++ linux-mm/drivers/net/myri10ge/myri10ge.c	2006-07-03 16:04:15.000000000 -0400
@@ -2734,11 +2734,10 @@
 		dev_err(&pdev->dev, "register_netdev failed: %d\n", status);
 		goto abort_with_irq;
 	}
-
-	printk(KERN_INFO "myri10ge: %s: %s IRQ %d, tx bndry %d, fw %s, WC %s\n",
-	       netdev->name, (mgp->msi_enabled ? "MSI" : "xPIC"),
-	       pdev->irq, mgp->tx.boundary, mgp->fw_name,
-	       (mgp->mtrr >= 0 ? "Enabled" : "Disabled"));
+	dev_info(dev, "%s IRQ %d, tx bndry %d, fw %s, WC %s\n",
+		 (mgp->msi_enabled ? "MSI" : "xPIC"),
+		 pdev->irq, mgp->tx.boundary, mgp->fw_name,
+		 (mgp->mtrr >= 0 ? "Enabled" : "Disabled"));
 
 	return 0;