From mboxrd@z Thu Jan  1 00:00:00 1970
From: Alexandru Dragoi <alex@zoomnet.ro>
Date: Wed, 11 Oct 2006 13:36:00 +0000
Subject: Re: [LARTC] Two outbound internet links, using one network interface
Message-Id: <452CF340.3070305@zoomnet.ro>
List-Id: <lartc.vger.kernel.org>
References: <45266C57.4010106@ma-isp.com>
In-Reply-To: <45266C57.4010106@ma-isp.com>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: lartc@vger.kernel.org

Dashamir Hoxha wrote:
> Using VLANs, you can separate the networks on the link level instead. 
> This is the same (in software) as using 2 different LAN ports (in 
> hardware).
>
> Thanks for the suggestion. I am trying it, and it seems very easy to 
> be used.
> However the problem is that it is not working.
> I am doing it like this:
>
> # /sbin/modprobe 8021q
> # /sbin/vconfig add eth0 2
> # /sbin/ip link set eth0.2 up
> # /sbin/ip addr add 192.168.10.2/24 dev eth0.2
>
> When I try: `ping 192.168.10.1` it says "Destination Host Unreachable".
> Both IPs are connected to the same switch. Does anybody know what can 
> be wrong?
>
> Dashamir
>
>
> _______________________________________________
> LARTC mailing list
> LARTC@mailman.ds9a.nl
> http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
You need a switch with 802.1q vlan support (cisco for example). The 
network card need to be pluged in a switch port in "trunk" mode, and the 
providers each in its access switch port in specified vlan (like 2).
_______________________________________________
LARTC mailing list
LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc