Re: [PATCH take 2] Atmel MACB ethernet driver

[Jeff Garzik <jgarzik@pobox.com>]

Haavard Skinnemoen wrote:
> Driver for the Atmel MACB on-chip ethernet module.
> 
> Tested on AVR32/AT32AP7000/ATSTK1000. I've heard rumours that it works
> with AT91SAM9260 as well, and it may be possible to share some code with
> the at91_ether driver for AT91RM9200.
> 
> Hardware documentation can be found in the AT32AP7000 data sheet,
> which can be downloaded from
> 
> http://www.atmel.com/dyn/products/datasheets.asp?family_id=682
> 
> Changes since previous version:
>   * Probe for PHY ID instead of depending on it being provided through
>     platform_data.
>   * Grab initial ethernet address from the MACB registers instead
>     of depending on platform_data.
>   * Set MII/RMII mode correctly.
> 
> These changes are mostly about making the driver more compatible with
> the at91 infrastructure.
> 
> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>

applied.

Thanks for submitting a nice, clean driver that was so painless to apply 
to the latest kernel.

I wish all vendors were as effective and efficient.

	Jeff