Re: Serial ATA does not find partitions (Hitachi HD, new? ATI controller) where old SATA works

[Hernan G Solari <hgsolari@gmail.com>]

> If you can set up a serial console, it would be better.  If not, can you
> please take a photo of the crash and post it?
>   
I am running short of elements, no digital camera o movil phone for the 
case or serial link.
However, what it is on the screen when it crashes follows:

KERNEL 2.6.23-rc8
-----------------------------------------------------begin screen dump
PCI: Bridge: 0000:00:14.4
  IO window: a000-afff
  MEM window: d0300000-d03fffff
  PREFETCH window: 50000000-53ffffff
PCI: Enabling device 0000:00:04.0 (0000 -> 0002)
PCI: Enabling device 0000:08:01.0 (0000 -> 0003)
ACPI: PCI Interrupt 0000:08:01.0[A] -> GSI 23 (level, low) -> IRQ 23
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 6, 262144 bytes)
TCP established hash table entries: 131072 (order: 9, 3145728 bytes)
TCP bind hash table entries: 65536 (order: 8, 1048576 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
Simple Boot Flag at 0x36 set to 0x1
Total HugeTLB memory allocated, 0
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
PCI: MSI quirk detected. MSI deactivated.
assign_interrupt_mode Found MSI capability
assign_interrupt_mode Found MSI capability
assign_interrupt_mode Found MSI capability
assign_interrupt_mode Found MSI capability
-------------------------------end screen dump

Not so difficult since most of these lines are also in a succesful boot 
with some of the ACPI turned off.

Hernan

-- 
Hernán Gustavo Solari, solari@df.uba.ar, http://www.df.uba.ar/~solari