From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peter Subject: Re: TNC3 Date: Sat, 20 Oct 2007 14:41:39 +0000 Message-ID: <471A13A3.8090206@pi4cc.nl> References: <4718F3B1.1020401@pi4cc.nl> <4719CDDB.3030604@ccr.jussieu.fr> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <4719CDDB.3030604@ccr.jussieu.fr> Sender: linux-hams-owner@vger.kernel.org List-Id: Content-Type: text/plain; charset="us-ascii"; format="flowed" To: Bernard Pidoux Cc: linux-hams@vger.kernel.org Hi all The trick is/was to put the TNC in KISS mode. The TNC3S has serveral programmas that can put into the memory. With the right dipswitch on the back you can startup a programma In my case rskiss. This put the TNC in KISS mode on the rs232 port at boot-up. Thanks for the emails! Peter Bernard Pidoux schreef: > Hi Peter, > > > Your info is absolutely right. > > However, you should put your TNC into kiss mode manually i.e. using a > terminal program to instruct it to change into kiss mode (see the > TNC3S manual). > > Communicating with the terminal program through serial port with TNC > is only possible if AX25 driver is NOT loaded. > > Then the order of operation is : > > Enter into your terminal program. > Choose the appropriate port and speed. > Reboot your TNC3S in order to make it detect your serial port speed > when pressing ENTER key (autobaud routine when TNC powerer up). > > Type the commands : > > INTFACE TERM and press return > > At this point you can monitor incoming traffic on both ports. > > > INTFACE KISS and press return > RESET and press return > > > Now your TNC is in kiss mode and you cannot communicate any more via > the terminal program. You will only see garbage on the screen. > > You can now load the AX25 mkiss driver and continue with AX25 > applications. > > > Note ; since I did not perform these commands for years (I left my > TNC2 in KISS mode forever) I may have forgotten the syntax) I do not > remember the name of Linux simple serial communication program... > > 73 de Bernard, f6bvp > > > Peter wrote: >> Hi >> >> I'am looking for support to get a TNC3S with 2 modem working >> With standard kissattach I got modem 1 on the air. >> >> In the ax25 how-to I found: >> If you have a dual port tnc and it is connected to >> your /dev/ttyS0 serial device at 9600 bps, >> the command: >> /usr/sbin/mkiss -s 9600 /dev/ttyS0 /dev/ptyp0 /dev/ptyp1 >> /usr/sbin/kissattach /dev/ttyp0 port1 >> /usr/sbin/kissattach /dev/ttyp1 port2 >> >> But none of the modem do work >> Who has a TNC3S running ? >> >> Peter >> PC2A >> - >> To unsubscribe from this list: send the line "unsubscribe linux-hams" in >> the body of a message to majordomo@vger.kernel.org >> More majordomo info at http://vger.kernel.org/majordomo-info.html >> >> > - > To unsubscribe from this list: send the line "unsubscribe linux-hams" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > > >