From: osprey67 <osprey67@yahoo.com>
To: netdev@vger.kernel.org
Subject: [PATCH 01/05] ipv6: RFC4214 Support (4)
Date: Mon, 12 Nov 2007 07:54:23 -0800 [thread overview]
Message-ID: <4738772F.6040907@yahoo.com> (raw)
In-Reply-To: <4734FCEF.3080301@yahoo.com>
From: Fred L. Templin <fred.l.templin@boeing.com>
This is experimental support for the Intra-Site Automatic
Tunnel Addressing Protocol (ISATAP) per RFC4214. It uses
the SIT module, and is configured using the unmodified
"ip" utility with device names beginning with: "isatap".
The following diffs are specific to the Linux 2.6.24-rc2
kernel distribution.
Signed-off-by: Fred L. Templin <fred.l.templin@boeing.com>
---
--- linux-2.6.24-rc2/include/linux/if.h.orig 2007-11-08 12:05:47.000000000 -0800
+++ linux-2.6.24-rc2/include/linux/if.h 2007-11-08 08:26:44.000000000 -0800
@@ -61,6 +61,7 @@
#define IFF_MASTER_ALB 0x10 /* bonding master, balance-alb. */
#define IFF_BONDING 0x20 /* bonding master or slave */
#define IFF_SLAVE_NEEDARP 0x40 /* need ARPs for validation */
+#define IFF_ISATAP 0x80 /* ISATAP interface (RFC4214) */
#define IF_GET_IFACE 0x0001 /* for querying only */
#define IF_GET_PROTO 0x0002
--- linux-2.6.24-rc2/include/linux/in.h.orig 2007-11-09 08:00:32.000000000 -0800
+++ linux-2.6.24-rc2/include/linux/in.h 2007-11-12 07:37:05.000000000 -0800
@@ -253,6 +253,14 @@ struct sockaddr_in {
#define ZERONET(x) (((x) & htonl(0xff000000)) == htonl(0x00000000))
#define LOCAL_MCAST(x) (((x) & htonl(0xFFFFFF00)) == htonl(0xE0000000))
+/* Special-Use IPv4 Addresses (RFC3330) */
+#define PRIVATE_10(x) (((x) & htonl(0xff000000)) == htonl(0x0A000000))
+#define LINKLOCAL_169(x) (((x) & htonl(0xffff0000)) == htonl(0xA9FE0000))
+#define PRIVATE_172(x) (((x) & htonl(0xfff00000)) == htonl(0xAC100000))
+#define TEST_192(x) (((x) & htonl(0xffffff00)) == htonl(0xC0000200))
+#define ANYCAST_6TO4(x) (((x) & htonl(0xffffff00)) == htonl(0xC0586300))
+#define PRIVATE_192(x) (((x) & htonl(0xffff0000)) == htonl(0xC0A80000))
+#define TEST_198(x) (((x) & htonl(0xfffe0000)) == htonl(0xC6120000))
#endif
#endif /* _LINUX_IN_H */
--- linux-2.6.24-rc2/include/net/addrconf.h.orig 2007-11-08 12:06:17.000000000 -0800
+++ linux-2.6.24-rc2/include/net/addrconf.h 2007-11-09 08:12:29.000000000 -0800
@@ -241,6 +241,14 @@ static inline int ipv6_addr_is_ll_all_ro
addr->s6_addr32[3] == htonl(0x00000002));
}
+#if defined(CONFIG_IPV6_ISATAP)
+/* only for IFF_ISATAP interfaces */
+static inline int ipv6_addr_is_isatap(const struct in6_addr *addr)
+{
+ return ((addr->s6_addr32[2] | htonl(0x02000000)) == htonl(0x02005EFE));
+}
+#endif
+
#ifdef CONFIG_PROC_FS
extern int if6_proc_init(void);
extern void if6_proc_exit(void);
next prev parent reply other threads:[~2007-11-12 18:37 UTC|newest]
Thread overview: 21+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-11-08 20:29 [PATCH 01/05] ipv6: RFC4214 Support (2) osprey67
2007-11-10 0:34 ` [PATCH 01/05] ipv6: RFC4214 Support (3) osprey67
2007-11-10 0:35 ` [PATCH 02/05] " osprey67
2007-11-10 0:35 ` [PATCH 03/05] " osprey67
2007-11-10 0:35 ` [PATCH 04/05] " osprey67
2007-11-10 0:35 ` [PATCH 05/05] " osprey67
2007-11-10 0:42 ` [PATCH 01/01] iproute2-2.6.23: " osprey67
2007-11-10 1:04 ` Patrick McHardy
2007-11-12 15:57 ` [PATCH 01/01] iproute2-2.6.23: RFC4214 Support (4) osprey67
2007-11-12 17:55 ` Templin, Fred L
2007-11-10 1:44 ` [PATCH 05/05] ipv6: RFC4214 Support (3) YOSHIFUJI Hideaki / 吉藤英明
2007-11-12 15:54 ` osprey67 [this message]
2007-11-12 15:54 ` [PATCH 02/05] ipv6: RFC4214 Support (4) osprey67
2007-11-12 15:54 ` [PATCH 03/05] " osprey67
2007-11-12 15:55 ` [PATCH 04/05] " osprey67
2007-11-12 15:55 ` [PATCH 05/05] " osprey67
2007-11-12 17:48 ` Templin, Fred L
2007-11-13 20:53 ` [PATCH 05/05] ipv6: RFC4214 Support (3) Stephen Hemminger
2007-11-14 5:05 ` David Miller
2007-11-14 5:11 ` Stephen Hemminger
2007-11-14 20:09 ` Vlad Yasevich
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4738772F.6040907@yahoo.com \
--to=osprey67@yahoo.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.