Re: [PATCH]: fix lro_gen_skb() alignment

[Andrew Gallatin <gallatin@myri.com>]

Herbert Xu wrote:
> On Fri, Nov 30, 2007 at 02:35:43PM -0500, Andrew Gallatin wrote:
>>> Isn't the value of 2 ethernet-specific (to round the 14-byte header up
>>> to 16)?  Given that the rest of the lro code is fairly careful to
>>> calculate mac_hdr_len etc it seems as if it would be cleaner to make
>>> this independent of the specific L2 being used.
>>>
>>> (And I plan on using the LRO module for IP-over-InfiniBand so this is
>>> not completely theoretical)
> 
> Good point!
> 
> We really should rename NET_IP_ALIGN so that both Ethernet and DMA
> occur in it somehow :)
> 
>> Good point.  I tend to think all the world is ethernet.
>> Perhaps the better way would be to simply add an alignment pad
>> field to lro_mgr?  When the driver initializes it, it specifies
>> any padding needed.  Ethernet drivers would specify 2.
> 
> Just pass in the mac_hdr_len, and calculate the padding as

That was my first thought as well, but it turns out that
when lro_gen_skb() is called via the out1 label, mac_hdr_len
may not be known.  It seemed simplest and cleanest to just
make it a field in lro_mgr.

Drew