Re: mmap + segfaults on MPC8349E

["R. Ebersole (VTI - new)" <rje@valleytech.com>]

David Hawkins wrote:

> Hi,


Hi.

>
> You haven't really provided enough information.


Sorry about that.  I grabbed one of the h/w guys to help out.

>
>> We wrote some simple drivers/modules to mmap() FPGA registers to user 
>> space.
>> At the moment, for testing, we reserve the upper x-MB of RAM, and 
>> mmap() there, instead.
>
>
> 1. The FPGA is located where? The local bus, or the PCI bus?
>    What frequency are you trying to operate at? 


On the local bus frequency is 33.0 MHz. (66.0 PCI_CLK_IN).  See the 
attached .cfg script for memory map.

>
>
> 2. If its on the local bus, do you access it using GPCM or UPM?
>    Have you setup either correctly?
>    Have you confirmed the bus timing with a logic analyzer? 


GPCM.
We have confirmed the timing both in functionality (in the debugger) and 
with a logic analyzer (plus oscope for setup and hold times).
We have stand-alone C-code that runs in CodeWarrior that bangs away at 
the registers of this device and the hardware runs perfectly using the 
.cfg script settings..

>
>
> 3. Have you created a bus functional model of the processor bus
>    that you have then run with your FPGA bus in ModelSim to
>    confirm that your FPGA performs correctly. 

Yes, we have.  Also, checked in h/w (see 2 above)

>
>
> 4. Have you tried burst and non-burst access by either using
>    DMA, or treating the memory area as cacheable or non-cacheable?
>    Have you checked those cases with simulation and then
>    with a scope or logic analyzer?


Always non-burst at this point.

>
> 5. Did you try running stand-alone tests in U-Boot, to go for a
>    more bare-metal debug approach?

I assume the bare-metal debug approach is using a JTAG debugger 
connection and CodeWarrior.  We started there and now are trying to 
access the same device(s) via linux drivers.

>
> No point in debugging software if you have no idea whether the
> hardware behaves. So confirm that you have tested your hardware
> first.
>
> My board design uses the MPC8349EA, I have an Altera Stratix II
> FPGA on the local bus. I use GPCM to access flash on the local
> bus via the FPGA, and UPM to access FPGA registers. I don't
> have boards yet, but I've got a pretty good handle on how the
> interface should work.
>
> Cheers,
> Dave
>
>
>

-- 

Sometimes I feel like a red shirt in the Star Trek episode of life.

--

This message contains confidential information and is intended only for the
individual named.  If you are not the intended recipient you should not
disseminate, distribute or copy this e-mail.  Please notify the sender
immediately by e-mail if you have received this e-mail by mistake and delete
this e-mail from your system.