Re: New question on that sata controller

[Robert Hancock <hancockr@shaw.ca>]

Gene Heskett wrote:
> Greetings;
> 
> When I asked about a sata controller earlier this week, I gave a link to it.  
> Unforch (maybe) when it actually arrived, the cards box showed a silicon 
> image chip, and the card had a via.  So much for getting what I ordered...
> 
> The required module then was sata_via, not sata_uli, and it seems to be 
> working ok.  However, this one claims its a raid controller according to an 
> lspci -v:
> 
> 01:0a.0 RAID bus controller: VIA Technologies, Inc. VT6421 IDE RAID Controller 
> (rev 50)
>         Subsystem: VIA Technologies, Inc. VT6421 IDE RAID Controller
>         Flags: bus master, medium devsel, latency 32, IRQ 19
>         I/O ports at 9400 [size=16]
>         I/O ports at 9800 [size=16]
>         I/O ports at 9c00 [size=16]
>         I/O ports at a000 [size=16]
>         I/O ports at a400 [size=32]
>         I/O ports at a800 [size=256]
>         [virtual] Expansion ROM at e9000000 [disabled] [size=64K]
>         Capabilities: [e0] Power Management version 2
> 
> I just noted that the Expansion ROM is disabled, but I didn't see any jumpers 
> to enable it on the card prior to installing it.  Does anyone know how this 
> is supposed to work?  I would like to make it directly bootable but I believe 
> this has to be 'enabled' for that.

It's usually normal for it to be disabled after boot, I believe. Are you 
getting anything showing up on boot indicating its BIOS is active?

> 
> I cannot find any references to this particular chip in a 'make xconfig' for 
> 2.6.24-rc5.
> 
> Should this be a concern, or is this one a 'Just Works(TM)' chipset?  This 
> card has 3 sata port connectors and one ide fitted.
> 
> Two rather pleasant side effects of going to the Biostar.tw site and finding a 
> newer bios and installing it on an M7NCD Pro mobo are:
> 
> 1: FSB now running at 400MHZ, was 333 before as it was not at all stable at 
> 400 and I have been told the XP-2800 Athlon only supports 333 and AMD's site 
> agrees.
> 
> 2: CPU temps are down around 13F.  CPU speed still the same at 2079MHZ 
> according to dmesg.
> 
> The reduced temps at a higher FSB indicates better interface timing, and if it 
> runs the rest of the night at 400 without a self reboot or crash, I'll leave 
> it there.
> 


-- 
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from hancockr@nospamshaw.ca
Home Page: http://www.roberthancock.com/