From mboxrd@z Thu Jan 1 00:00:00 1970 From: MillTek Date: Tue, 12 Feb 2008 17:39:35 +0000 Subject: [lm-sensors] Kernel 2.6.24 and the F1882G chip Message-Id: <47B1D9D7.2010200@verizon.net> List-Id: References: <47B1C83C.2050703@verizon.net> In-Reply-To: <47B1C83C.2050703@verizon.net> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org I've just been told that I've screwed up by using the 'reply' button. Apparently this caused my initial posts to become threaded into other topics instead of starting a new on which can cause confusion. I apologize for that. Anyway, here's my problem; Kernel 2.6.24 for my distro (Arch Linux) came out in the last few days. My board has a Fintek F1882g chip. It means that I can finally get voltage and fan speeds for the board, so thanks for that. I am wondering how I correctly calculate the correct offset and factors for the voltage numbers? This is what GKrellm says; Vcor1 1.66 factor 1 offset 0 Vcor2 1.24 factor 1 offset 0 +3.3v 2.83 factor 3 offset 0 +5v 4.82 factor 4.98 offset 0 +12v 3.84 factor 4.0 offset 0 -12v -4.35 factor -4.0 offset 0 -5v -1.51 factor -1.667 offset 0 in7 1.66 factor 1 offset 0 in8 1.54 factor 1 offset 0 If there's a website that I should visit can anyone supply a link?? Jim _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors