Re: Oops with TQM5200 on TQM5200

[Anatolij Gustschin <agust@denx.de>]

Hello Wolfgang,

Wolfgang Grandegger wrote:

> I just tried Linux 2.6.25-rc6 on my TQM5200 module and got the attached
> oops. Are there any known patches fixing the problems?

try the patch below for tqm5200.dts, rebuild dtb and boot
again. Not sure if it works for Linux 2.6.25-rc6, but for
2.6.25-rc3 it does.

Anatolij
--
 diff --git a/arch/powerpc/boot/dts/tqm5200.dts b/arch/powerpc/boot/dts/tqm5200.dts
index c86464f..7c23bb3 100644
--- a/arch/powerpc/boot/dts/tqm5200.dts
+++ b/arch/powerpc/boot/dts/tqm5200.dts
@@ -83,6 +83,7 @@
 		};
 
 		dma-controller@1200 {
+			device_type = "dma-controller";
 			compatible = "fsl,mpc5200-bestcomm";
 			reg = <1200 80>;
 			interrupts = <3 0 0  3 1 0  3 2 0  3 3 0
@@ -127,10 +128,25 @@
 		ethernet@3000 {
 			device_type = "network";
 			compatible = "fsl,mpc5200-fec";
-			reg = <3000 800>;
+			reg = <3000 400>;
 			local-mac-address = [ 00 00 00 00 00 00 ];
 			interrupts = <2 5 0>;
 			interrupt-parent = <&mpc5200_pic>;
+			phy-handle = <&phy0>;
+		};
+
+		mdio@3000 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "fsl,mpc5200b-mdio";
+			reg = <3000 400>;       // fec range, since we need to setup fec interrupts
+			interrupts = <2 5 0>;   // these are for "mii command finished", not link changes & co.
+			interrupt-parent = <&mpc5200_pic>;
+
+			phy0:ethernet-phy@0 {
+				device_type = "ethernet-phy";
+				reg = <0>;
+			};
 		};
 
 		ata@3a00 {