From mboxrd@z Thu Jan  1 00:00:00 1970
From: Sander Vermin <sander@vermin.nl>
Date: Mon, 14 Apr 2008 10:10:05 +0200
Subject: [U-Boot-Users] Uboot (AT91 tree) macb in MII mode
Message-ID: <4803115D.5050603@vermin.nl>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi All,

I have been struggling the last week to get the macb Ethernet driver in 
MII mode.

[in short]
I have communication over the MDIO interface, my activity led blinks but 
no ehternet.

[the long story]
I have a custom board build out of the schematics of the AT91SAM9260EK 
board. On my boar I did not use the DM9161 but the KS8721chip. On the 
ATMEL board the PHY works in RMII mode, on my board I used MII mode like 
this board from OLIMEX [1].

Olimex was kind enough to make Uboot nandflash build working with there 
board, And deliver sources I cant compile, due to an error: Hardware 
float vs software float. But I want a dataflash version because I am 
using a BGA chip with nandflash bug.

In my current setup I use the latest git of the AT91 tree with the 
following defines:
#define CONFIG_MACB            1
#define    CONFIG_MII                1
#undef CONFIG_RMII
#define CONFIG_NET_MULTI        1
#define CONFIG_NET_RETRY_COUNT        5000
#define CONFIG_RESET_PHY_R        1

With this config I have the MDIO interface working, when I try to ping 
or TFTP I only get time outs / host not alive errors.

Is there someone out there how has the MII mode working?

Best regards,

Sander


[1] http://www.olimex.com/dev/sam9-L9260.html (schematics on the bottom 
of the page)