From mboxrd@z Thu Jan 1 00:00:00 1970 Message-ID: <48349D40.9070707@domain.hid> Date: Wed, 21 May 2008 18:08:00 -0400 From: Michael Galea MIME-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1; format=flowed Content-Transfer-Encoding: 7bit Subject: [Xenomai-help] Enable I-PIPE - kernel boot hangs in mpc836x_mds List-Id: Help regarding installation and common use of Xenomai List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , To: xenomai@xenomai.org I'm trying to bring xenomai up on an Freescale mpc836x_mds board. I'm using the ipipe-2.6.24-powerpc-2.1-02 branch of the git tree at Denx. The kernel boots fine with ipipe disabled, nfs root mounting its file system. But as soon as I enable ipipe in the kernel I get.. ... RPC: Registered udp transport module. RPC: Registered tcp transport module. IP-Config: Complete: device=eth0, addr=10.128.10.234, mask=255.0.0.0, gw=10.128.0.253, host=10.128.10.234, domain=, nis-domain=(none), bootserver=10.128.10.10, rootserver=10.128.10.10, rootpath= Looking up port of RPC 100003/2 on 10.128.10.10 irq 33, desc: c02746c0, depth: 0, count: 0, unhandled: 0 irq 33, desc: c02746c0, depth: 0, count: 0, unhandled: 0 And it hangs. Since this is the place where the kernel usually finds its PHY, I might suspect its an issue with that.. I'm currently trying to get Denx's 2.6.20 branch running but its freezing after loading the device tree, so I have some issues there. Can anyone having success with this board report what kernel they are using? Thanks -- Michael Galea 30 Whitmore Road Woodbridge, Ontario, Canada, L4L 7Z4 Ph: (905) 266-1745 Fx: (905) 856-1995 www.ruggedcom.com