Re: [PATCH v2 1/6] ether: enhancement for VMDQ support

[Thomas Monjalon <thomas.monjalon-pdR9zngts4EAvxtiuMwx3w@public.gmane.org>]

2014-10-16 18:07, Chen Jing D:
>  /**
> + *  Simple flags to indicate RX mq mode, which can be used independently or combined
> + *  in enum rte_eth_rx_mq_mode definition.
> + */
> +#define ETH_MQ_RX_RSS_FLAG  0x1
> +#define ETH_MQ_RX_DCB_FLAG  0x2
> +#define ETH_MQ_RX_VMDQ_FLAG 0x4

The comment would be more useful by explaining that these flags are used
for rte_eth_conf.rxmode.mq_mode.

> +	/**< None of DCB,RSS or VMDQ mode */
> +	ETH_MQ_RX_NONE = 0,
> +
> +	/**< For RX side, only RSS is on */
> +	ETH_MQ_RX_RSS = ETH_MQ_RX_RSS_FLAG,
> +	/**< For RX side,only DCB is on. */
> +	ETH_MQ_RX_DCB = ETH_MQ_RX_DCB_FLAG,
> +	/**< Both DCB and RSS enable */
> +	ETH_MQ_RX_DCB_RSS = ETH_MQ_RX_RSS_FLAG | ETH_MQ_RX_DCB_FLAG,
> +
> +	/**< Only VMDQ, no RSS nor DCB */
> +	ETH_MQ_RX_VMDQ_ONLY = ETH_MQ_RX_VMDQ_FLAG,
> +	/**< RSS mode with VMDQ */
> +	ETH_MQ_RX_VMDQ_RSS = ETH_MQ_RX_RSS_FLAG | ETH_MQ_RX_VMDQ_FLAG,
> +	/**< Use VMDQ+DCB to route traffic to queues */
> +	ETH_MQ_RX_VMDQ_DCB = ETH_MQ_RX_VMDQ_FLAG | ETH_MQ_RX_DCB_FLAG,
> +	/**< Enable both VMDQ and DCB in VMDq */
> +	ETH_MQ_RX_VMDQ_DCB_RSS = ETH_MQ_RX_RSS_FLAG | ETH_MQ_RX_DCB_FLAG |
> +				 ETH_MQ_RX_VMDQ_FLAG,

Doxygen comments placed before should start with /** not /**<.

> +	/** Specify the queue range belongs to VMDQ pools if VMDQ applicable. */
> +	uint16_t vmdq_queue_base;
> +	uint16_t vmdq_queue_num;

Please explain what mean the values in vmdq_queue_base and vmdq_queue_num.

Thanks
-- 
Thomas