From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from www2.team-ctech.de (www2.team-ctech.de [62.146.20.117]) (using TLSv1 with cipher AES256-SHA (256/256 bits)) (Client did not present a certificate) by ozlabs.org (Postfix) with ESMTPS id 76836DDE1F for ; Tue, 9 Sep 2008 17:30:20 +1000 (EST) Message-ID: <48C62603.7080606@team-ctech.de> Date: Tue, 09 Sep 2008 09:30:11 +0200 From: Georg Schardt MIME-Version: 1.0 To: Neeraj Garg Subject: Re: EDK10.1 and emaclite References: <48C5F6ED.4000804@cdac.in> In-Reply-To: <48C5F6ED.4000804@cdac.in> Content-Type: text/plain; charset=ISO-8859-1; format=flowed Cc: linuxppc-embedded@ozlabs.org List-Id: Linux on Embedded PowerPC Developers Mail List List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Hi again, mmh, there is no kernel message with PHY detection, but all PHY drivers are compiled in. i looked at my xps project and there is only one ip-core "Ethernet_MAC" with type "xps_ethernetlite". is it possible that the phy connection is missing ? i use the base system builder with the board support files supported from avnet. where can i look for the ethernet speed ? the ethernetlite ip has no speed options thanks for your help georg Neeraj Garg wrote: > Hi Georg, > > Can you post linux bootup message where its says PHY is detected at > paticular address, and check with your hardware what is actual address > of PHY. Also I would like to know the configuration of your hardware > whether its configured of 10MBPS OR 100MBPS. > > > ------------------------------------------------------------------------------------------ > > -- > Neeraj Garg > > > > Message: 3 > Date: Mon, 08 Sep 2008 18:29:53 +0200 > From: Georg Schardt > Subject: EDK10.1 and emaclite > To: linuxppc-embedded@ozlabs.org > Message-ID: <48C55301.4070208@team-ctech.de> > Content-Type: text/plain; charset=ISO-8859-1; format=flowed > > Hi all, > > im trying to use the emaclite core which comes with the EDK10.1 with > the 2.6.26 kernel from git.xilinx.com on virtex4fx12 minimodul. the > emac is detect by the kernel: > > xilinx_emaclite xilinx_emaclite.0: MAC address is now 2: 0: 0: 0: 0: 0 > xilinx_emaclite xilinx_emaclite.0: using fifo mode. > xilinx_emaclite xilinx_emaclite.0: Xilinx EMACLite at 0x81000000 > mapped to 0xC5060000, irq=0 > > i can change the mac-address with ifconfig and i can give an > ip-address to the device, > but a ping is not possible and arp is not working. i think that the > phy is not working right. > > has someone others the same problem ? what can i changed ? i have > tried out all possible phy driver in the linux kernel > > a setup with the lltemac is working fine, but i want to use the emaclite > > thanks > regards > georg >