Re: [IRC/patches] Failed octopus merge does not clean up

[Andreas Ericsson <ae@op5.se>]

Jakub Narebski wrote:
> Dnia wtorek 16. września 2008 02:20, Junio C Hamano napisał:
>> Junio C Hamano <gitster@pobox.com> writes:
>>> Thomas Rast <trast@student.ethz.ch> writes:
>>>
>>>> The merge says
>>>>
>>>>   Trying simple merge with 5b3e4bb1c2d88d6967fb575729fbfc86df5eaec9
>>>>   Simple merge did not work, trying automatic merge.
>>>>   Auto-merging foo
>>>>   ERROR: Merge conflict in foo
>>>>   fatal: merge program failed
>>>>   Automated merge did not work.
>>>>   Should not be doing an Octopus.
>>>>   Merge with strategy octopus failed.
>>> ...
>>> Read the second from the last line of what you were told by git.  Run "git
>>> reset --hard" after that, perhaps.
> 
> The problem, as far as I understand it, is not that octopus merge fails.
> The problem is that it fails halfway, and it leaves working are in
> inconsistent state: git-status output with its "unmerged" suggests that
> we are in the middle of the merge, but we are not.
> 
>> By the way, there are three failure modes in Octopus.
>>
>>  (0) your index (not work tree) is dirty; this is not limited to octopus
>>      merge but any merge will be refused;
> 
> IIRC the idea of stashing away changes, doing merge, and then unstashing
> was shot down as encouraging bad workflows, and more often than not
> leading only to mess in workdir and index.
> 
>>  (1) while it merges other heads one-by-one, it gets conflicts on an
>>      earlier one, before it even attempts to merge all of them.  Recording
>>      the heads that it so far attempted to merge in MERGE_HEAD is wrong
>>      (the result won't be an Octopus the end user wanted to carete), and
>>      recording all the heads the user gave in MERGE_HEAD is even more
>>      wrong (it hasn't even looked at the later heads yet, so there is no
>>      way for the index or work tree to contain anything from them).
>>
>>      The above is hitting this case.
> 
> IMVHO the correct solution would be to rollback changes to the state
> before attempting a merge. I'd rather 'octopus' did its thing as
> transaction; contrary to ordinary merges if merge fails it doesn't
> mean necessary that it is in the state of resolvable conflict, state
> we can stop at. Perhaps (if it is still a shell script, doing git-stash
> at beginning, and either dropping or popping the stash at the end;
> or just saving old index if it is built-in).
> 
> 
> BTW. does it mean that "git merge a b" might be not the same as
> "git merge b a"?
> 

No. Git merges all the sub-things together and then merges the result
of that jumble into the branch you're on.

Someone might have to correct me on that, but that's as far as I've
understood it.

-- 
Andreas Ericsson                   andreas.ericsson@op5.se
OP5 AB                             www.op5.se
Tel: +46 8-230225                  Fax: +46 8-230231