From mboxrd@z Thu Jan 1 00:00:00 1970 From: Brian Date: Sun, 14 Dec 2008 01:28:14 +1000 Subject: [ath9k-devel] 2.6.28-rc8-wl Connection status bug? In-Reply-To: <1229026221.6240.11.camel@jm-desktop> References: <20081211162213.GA28193@jm.kir.nu> <1229026221.6240.11.camel@jm-desktop> Message-ID: <4943D48E.1000208@astronomicalresearchaustralia.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ath9k-devel@lists.ath9k.org Hi, I have been having this 'problem' since rc7 Just installed the above kernel as the change log indicate some changes in this area for ath9k. The problem is that my router displays IP Address Mode Rate (Mbps) Signal (%) 0.0.0.0 802.11g 130 76 Now it should not be possible to get 130 out of 11g. My router is set up to do both 11g/n, see below. Prior to rc7 it used to show 11n and 300Mbps. Not sure if it is relevant but I think the only thing I have changed in the router is turning on the Wi-Fi Protected Setup. How can I provide more detail/tests By the way, looking through the change log I cannot believe how much effort is going into this. Thanks one and all. Brian Wireless LAN Wireless Radio : Enabled 802.11 Mode : Mixed 802.11n and 802.11g Channel Width : 40MHz Channel : 4 Secondary Channel : 8 WISH : Active Wi-Fi Protected Setup : Enabled/Configured