From mboxrd@z Thu Jan 1 00:00:00 1970 From: Brian Date: Tue, 16 Dec 2008 01:12:29 +1000 Subject: [ath9k-devel] Dlink 655 Wireless Mbs In-Reply-To: <18757.58070.638243.233974@gargle.gargle.HOWL> References: <4944109B.9040305@gmail.com> <18757.56207.437842.577705@gargle.gargle.HOWL> <4945DE75.10006@astronomicalresearchaustralia.org> <18757.58070.638243.233974@gargle.gargle.HOWL> Message-ID: <494673DD.9080100@astronomicalresearchaustralia.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ath9k-devel@lists.ath9k.org Sujith, >> Does this mean if I do a git-pull now I should get this? >> Or is there some delay? >> > > You should get it, since the commit is in wireles-testing. > I got Already up-to-date so you must have updated a few days ago before my last go. The wireless link seems to be a lot more stable and I have not had a lockup since. However, I still have the problem where my router shows. IP Address Mode Rate (Mbps) Signal (%) 0.0.0.0 802.11g 130 62 Now I thought this might just have been a router issue so I upgraded my firmware(glutton for punishment:). The update went well I am now at firmware Version: 1.21 Hardware Version: A3 Product Page: DIR-655 (no-securespot version) Again this seems to have improved things a lot. But I am still left with the problem above. Given that the wireless says it is set up for 11n Wireless Enabled 802.11 Mode : Mixed 802.11n and 802.11g Channel Width : 40MHz Channel : 8 Secondary Channel : 4 WISH : Active Wi-Fi Protected Setup : Enabled/Configured I do not understand why it says 11g Is there any way to show the actual MBs from the host side? I am in the process of setting up iperf. Thanks, Brian