From mboxrd@z Thu Jan 1 00:00:00 1970 From: Hans de Goede Date: Mon, 15 Dec 2008 22:34:17 +0000 Subject: Re: [lm-sensors] F8000 support added to f71882fg driver, Message-Id: <4946DB69.1000002@redhat.com> List-Id: References: <20081215180300.GA6612@rho> In-Reply-To: <20081215180300.GA6612@rho> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org Chuan-kai Lin wrote: > On Mon, Dec 15, 2008 at 11:16:02PM +0100, Hans de Goede wrote: >>> 3. The full-speed number seems to record the maximum measured fan >>> speed instead of the maximum possible fan speed. >> So this gets updated by hardware? This is not mentioned anywhere in >> the dcos, but if that is the case that would be good! > > Appears to be the case. See previous message attachment: in loaded.txt > the _full_speed values are higher than in idle.txt. > >>> 4. I cannot change fan speed by altering tempX_auto_pointY_pwm >>> values. However, both the CPU fan and the case fan do speed up >>> when the system gets warm. >> what does cat pwmX_enable give you, if it gives 3, the relevant pwm is >> in thermostat mode see the documentation I also attached. > > See previous message attachment: they both report 2. > Hmm, can you be so kind as to resend, I already deleted it. Regards, Hans _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors