Re: PROBLEM: Can't boot a (HZ = 1000) kernel using an AMD Phenom-II processor

[Mark Hounschell <dmarkh@cfl.rr.com>]

Andreas Herrmann wrote:
> On Fri, Feb 20, 2009 at 10:43:03AM -0500, Mark Hounschell wrote:
>> Andreas Herrmann wrote:
>>> On Thu, Feb 19, 2009 at 10:54:19AM -0500, Mark Hounschell wrote:
>>>> Borislav Petkov wrote:
>>>>> On Thu, Feb 19, 2009 at 10:16:40AM -0500, Mark Hounschell wrote:
>>>>>> Andreas Herrmann wrote:
>>>>>>> Hi Mark,
>>>>>>>
>>>>>>> Can you please provide us output of lspci -vvxxx.
>>>>>>> (Please run this as root.)
>>>>>>>
>>>> Attached...
>>>>
>>>>
>>>>>>> Furthermore you can try booting your 1000HZ kernel
>>>>>>> with following kernel command lines:
>>>>>>>
>>> Thanks for trying this out.
>>> But nothing suspicious found. I.e. timer/hpet interrupt is enabled
>>> and its routing seems to be ok.
>>>
>>> Here's one more check that's worth trying: In one of your logs I've
>>> seen that HPET id reports 3 timers but later on 4 timers were detected
>>> for HPET.
>>>
>>> To check what's going on I'd like to see the HPET configuration in the
>>> course of booting your system.  Please apply attached patch and boot
>>> with hpet=debug -- both with 250HZ and with 1000HZ -- and provide dmesg
>>> output.
>>>
>>>
>> Here is the short 1000Hz bootlog. I'm afraid non of your debug output made it
>> out however.
> 
> Sigh.
> 
>> I thought it was because it just wasn't getting that far but
>> looking at the 250Hz log I don't see any there either???
> 
> 
>> The patch applied (with fuz) to both kernel sources and I built/installed them
>> from clean. I don't find any messages starting with "hpet:" in either trace???
> 
> Your 250HZ kernel was built on Feb, 2nd, right?
> So the patch wasn't applied I guess, no?
> 

The patch was applied. These 2 kernels were built from "clean" at the same time.

>> Linux version 2.6.28.3-1000Hz (root@harley) (gcc version 4.3.1 20080507
>> (prerelease) [gcc-4_3-branch revision 135036] (SUSE Linux) ) #7 SMP PREEMPT Fri Feb
>> 20 09:01:29 EST 2009
> 
> I assume the patch was aplied.
> 

Yes it was.

>> Linux version 2.6.28.3-250Hz (root@harley) (gcc version 4.3.1
>> 20080507 (prerelease) [gcc-4_3-branch revision 135036] (SUSE Linux)
>> ) #7 SMP PREEMPT Fri Feb 2 0 09:01:54 EST 2009
> 
                             ^
                             |

Look closer it was built Feb 20 09:01:53. Not Feb 2 0 09:01:53.
There is a space between the 2 and 0 because of a minicom linewrap I guess.


> Here I doubt that's the right kernel -- at least it was not built today.
> Can you please double check this.
> 

My double check is correct. both these kernels were built this morning from
"clean" after your patch was applied.


I will do it all again from scratch if you wish.

Not a problem. I am at your disposal. I'm not ignorant when it comes to building
and installing kernels.

Standing by.
Mark