[U-Boot] [PATCH] at91: Support for the at91sam9g20 : Atmel 400Mhz ARM 926ej-s SOC.

[Ben Warren <biggerbadderben@gmail.com>]

Hi Nicolas,

Nicolas Ferre wrote:
<snip>
> diff --git a/drivers/net/macb.c b/drivers/net/macb.c
> index af0409b..6de0a04 100644
> --- a/drivers/net/macb.c
> +++ b/drivers/net/macb.c
> @@ -447,14 +447,14 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
>  	/* choose RMII or MII mode. This depends on the board */
>  #ifdef CONFIG_RMII
>  #if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
> -    defined(CONFIG_AT91SAM9263)
> +    defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20)
>  	macb_writel(macb, USRIO, MACB_BIT(RMII) | MACB_BIT(CLKEN));
>  #else
>  	macb_writel(macb, USRIO, 0);
>  #endif
>  #else
>  #if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
> -    defined(CONFIG_AT91SAM9263)
> +    defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20)
>  	macb_writel(macb, USRIO, MACB_BIT(CLKEN));
>  #else
>  	macb_writel(macb, USRIO, MACB_BIT(MII));
>   
Please find a more generic way of doing this.  There should be no 
board/cpu specific #ifdefs in common drivers.  While you're at it, fix 
up the existing ones.

regards,
Ben