Re: 2.6.29: EXT4: __ext4_get_inode_loc errors after s2disk

[Niel Lambrechts <niel.lambrechts@gmail.com>]

On 03/26/2009 12:30 AM, Pavel Machek wrote:
> On Tue 2009-03-24 22:25:57, Niel Lambrechts wrote:
>> After upgrading to 2.6.29 I get the below errors after resuming from
>> hibernating with s2disk. I ran fsck and tried doing the same thing again
>> in 2.6.28.9-pae, but do not get any errors there.
> 
> what kind of disk/what kind of controller is that?

Hi Pavel,

It is a Lenovo W500 Thinkpad.

lspci shows:

00:1f.2 SATA controller: Intel Corporation ICH9M/M-E SATA AHCI
Controller (rev 03)

and for the disk, hdparm shows:
/dev/sda:

 Model=HITACHI HTS722020K9SA00  FDE            , FwRev=DC4LC75A,
SerialNo=080726DP0470DTGMUNPC
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=DualPortCache, BuffSize=15203kB, MaxMultSect=16, MultSect=?16?
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=390721968
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4
 DMA modes:  mdma0 mdma1 mdma2
 UDMA modes: udma0 udma1 udma2 udma3 udma4 udma5 *udma6
 AdvancedPM=yes: mode=0x80 (128) WriteCache=enabled
 Drive conforms to: unknown:  ATA/ATAPI-2,3,4,5,6,7

 * signifies the current active mode


Niel