From: Jeff Garzik <jeff@garzik.org>
To: Arjan van de Ven <arjan@infradead.org>
Cc: Mark Lord <lkml@rtr.ca>,
Linus Torvalds <torvalds@linux-foundation.org>,
Theodore Tso <tytso@mit.edu>, Jens Axboe <jens.axboe@oracle.com>,
Linux Kernel Developers List <linux-kernel@vger.kernel.org>,
Ext4 Developers List <linux-ext4@vger.kernel.org>
Subject: Re: [GIT PULL] Ext3 latency fixes
Date: Mon, 06 Apr 2009 01:47:33 -0400 [thread overview]
Message-ID: <49D99775.9030104@garzik.org> (raw)
In-Reply-To: <20090405164831.7ad01c20@infradead.org>
Arjan van de Ven wrote:
> On Sun, 05 Apr 2009 16:57:21 -0400
> Jeff Garzik <jeff@garzik.org> wrote:
>> We set it in libata-scsi.c:ata_scsi_dev_config() based on
>> ata_id_is_ssd()
>>
>> That hueristic probably assumes Intel SSDs or something :/
>
> you mean the "rpm" set to '1' ?
> I was pretty sure that that was industry standard...
A -new- industry standard. You can certainly create a compliant SSD
while only conforming to ATA-7, for example. Some older IDE flash
devices pretend they are normal hard drives in almost every respect, too.
Jeff
next prev parent reply other threads:[~2009-04-06 5:48 UTC|newest]
Thread overview: 72+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-04-03 7:01 [GIT PULL] Ext3 latency fixes Theodore Ts'o
2009-04-03 7:01 ` [PATCH 1/4] block_write_full_page: Use synchronous writes for WBC_SYNC_ALL writebacks Theodore Ts'o
2009-04-03 7:01 ` [PATCH 2/4] ext3: Use WRITE_SYNC for commits which are caused by fsync() Theodore Ts'o
2009-04-03 7:01 ` [PATCH 3/4] ext3: Add replace-on-truncate hueristics for data=writeback mode Theodore Ts'o
2009-04-03 7:01 ` [PATCH 4/4] ext3: Add replace-on-rename " Theodore Ts'o
2009-04-03 15:01 ` EXT4 in embedded systems Nick Hennenfent (nhennefe)
2009-04-03 16:06 ` Eric Sandeen
2009-04-03 17:15 ` Nick Hennenfent (nhennefe)
2009-04-03 18:24 ` [GIT PULL] Ext3 latency fixes Linus Torvalds
2009-04-03 18:47 ` Jens Axboe
2009-04-03 19:13 ` Theodore Tso
2009-04-03 21:01 ` Chris Mason
2009-04-03 19:02 ` Linus Torvalds
2009-04-03 20:41 ` Linus Torvalds
2009-04-04 13:57 ` Theodore Tso
2009-04-04 15:16 ` Jens Axboe
2009-04-04 15:57 ` Linus Torvalds
2009-04-04 16:06 ` Linus Torvalds
2009-04-04 17:36 ` Jens Axboe
2009-04-04 17:34 ` Jens Axboe
2009-04-04 17:44 ` Linus Torvalds
2009-04-04 18:00 ` Trenton D. Adams
2009-04-04 18:01 ` Jens Axboe
2009-04-04 18:10 ` Linus Torvalds
2009-04-04 23:22 ` Theodore Tso
2009-04-04 23:33 ` Arjan van de Ven
2009-04-05 0:10 ` Theodore Tso
2009-04-05 15:05 ` Arjan van de Ven
2009-04-05 17:01 ` Linus Torvalds
2009-04-05 17:15 ` Mark Lord
2009-04-05 20:57 ` Jeff Garzik
2009-04-05 23:48 ` Arjan van de Ven
2009-04-06 2:32 ` Mark Lord
2009-04-06 5:47 ` Jeff Garzik [this message]
2009-04-07 18:18 ` Linus Torvalds
2009-04-07 18:22 ` Linus Torvalds
2009-04-07 19:40 ` [PATCH libata: add SSD detection hueristic; move SSD setup to ata_dev_configure (was Re: [GIT PULL] Ext3 latency fixes) Jeff Garzik
2009-04-09 18:21 ` Tejun Heo
2009-04-18 3:02 ` George Spelvin
2009-04-06 8:13 ` [GIT PULL] Ext3 latency fixes Jens Axboe
2009-04-05 18:56 ` Arjan van de Ven
2009-04-05 19:34 ` Linus Torvalds
2009-04-05 20:06 ` Arjan van de Ven
2009-04-06 6:25 ` Jens Axboe
2009-04-06 6:05 ` Theodore Tso
2009-04-06 6:23 ` Jens Axboe
2009-04-06 8:16 ` Jens Axboe
2009-04-06 14:48 ` Linus Torvalds
2009-04-06 15:09 ` Jens Axboe
2009-04-06 6:15 ` Jens Axboe
2009-04-04 20:18 ` Ingo Molnar
2009-04-06 21:50 ` Lennart Sorensen
2009-04-07 13:31 ` Mark Lord
2009-04-07 14:48 ` Lennart Sorensen
2009-04-07 19:21 ` Mark Lord
2009-04-07 19:57 ` Lennart Sorensen
2009-04-04 20:56 ` Arjan van de Ven
2009-04-06 7:06 ` Jens Axboe
2009-04-07 15:39 ` Indan Zupancic
2009-04-04 19:18 ` Theodore Tso
2009-04-06 8:12 ` Jens Axboe
2009-04-04 22:13 ` Linus Torvalds
2009-04-04 22:19 ` Linus Torvalds
2009-04-05 0:20 ` Theodore Tso
2009-04-03 19:54 ` Theodore Tso
-- strict thread matches above, loose matches on Subject: below --
2009-04-08 23:40 Theodore Ts'o
2009-04-09 15:49 ` Linus Torvalds
2009-04-09 16:23 ` Chris Mason
2009-04-09 17:49 ` Jan Kara
2009-04-09 18:10 ` Chris Mason
2009-04-09 19:04 ` Jan Kara
2009-04-09 17:36 ` Jan Kara
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=49D99775.9030104@garzik.org \
--to=jeff@garzik.org \
--cc=arjan@infradead.org \
--cc=jens.axboe@oracle.com \
--cc=linux-ext4@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=lkml@rtr.ca \
--cc=torvalds@linux-foundation.org \
--cc=tytso@mit.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.