From: David Arendt <admin-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
To: NILFS Users mailing list <users-JrjvKiOkagjYtjvyW6yDsg@public.gmane.org>
Subject: Re: nilfs_cpfile_delete_checkpoints: cannot delete block
Date: Mon, 04 May 2009 06:16:24 +0200 [thread overview]
Message-ID: <49FE6C18.3050707@prnet.org> (raw)
In-Reply-To: <20090503.170847.69363313.ryusuke-sG5X7nlA6pw@public.gmane.org>
Hi,
This night. I had lots of:
nilfs_btree_propagate: key = 67, level == 0
On the parition where cleanerd has failed.
A try to umount it resulted in a hang with the following message:
NILFS warning (device sda10): nilfs_segctor_destroy: dirty file(s) after
the final construction
Bye,
David Arendt
Ryusuke Konishi wrote:
> Hi David,
> On Sun, 03 May 2009 00:55:43 +0200, David Arendt wrote:
>
>> Hi,
>>
>> Until now nilfs-2.0.12 has run very stable without data corruption.
>> However on one partition (600G) I have got the following errors while
>> running the cleaner:
>>
>> nilfs_cpfile_delete_checkpoints: cannot delete block
>> NILFS: GC failed during preparation: cannot delete checkpoints: err=-2
>>
>> This is a partition mainly holding large temporary render files (can be
>> up to 25gb/file). There are currently 132702 snapshots.
>>
>> As this partition is not used during the next few days, I will leave it
>> with the error so if you would like me to test further things, please
>> let me know.
>>
>> Bye,
>> David Arendt
>>
>
> I have reviewed the function in question, but could not find any
> likely problems.
>
> Could you try the following patch?
>
> It's applicable to v2.0.12.
>
> I have some pending patches later than 2.0.12, but they seem to be
> independent with your problem.
>
> Thanks,
> Ryusuke Konishi
> --
> diff --git a/fs/cpfile.c b/fs/cpfile.c
> index 038d660..9a6a6ae 100644
> --- a/fs/cpfile.c
> +++ b/fs/cpfile.c
> @@ -342,8 +342,12 @@ int nilfs_cpfile_delete_checkpoints(struct inode *cpfile,
> cpfile, cno);
> if (ret == 0)
> continue;
> - printk(KERN_ERR "%s: cannot delete block\n",
> - __func__);
> + printk(KERN_ERR "%s: cannot delete block: "
> + "cno=%llu, range = [%llu, %llu)\n",
> + __func__,
> + (unsigned long long)cno,
> + (unsigned long long)start,
> + (unsigned long long)end);
> goto out_sem;
> }
> }
> diff --git a/fs/dat.c b/fs/dat.c
> index 523eee7..7463301 100644
> --- a/fs/dat.c
> +++ b/fs/dat.c
> @@ -381,11 +381,9 @@ int nilfs_dat_translate(struct inode *dat, __u64 vblocknr, sector_t *blocknrp)
> entry = nilfs_palloc_block_get_entry(dat, vblocknr, entry_bh, kaddr);
> blocknr = le64_to_cpu(entry->de_blocknr);
> if (blocknr == 0) {
> -#ifdef CONFIG_NILFS_DEBUG
> printk(KERN_DEBUG "%s: invalid virtual block number: %llu\n",
> __func__, (unsigned long long)vblocknr);
> - BUG();
> -#endif
> + WARN_ON(1);
> ret = -ENOENT;
> goto out;
> }
>
next prev parent reply other threads:[~2009-05-04 4:16 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-05-02 22:55 nilfs_cpfile_delete_checkpoints: cannot delete block David Arendt
[not found] ` <49FCCF6F.3040101-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-03 8:08 ` Ryusuke Konishi
[not found] ` <20090503.170847.69363313.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-03 9:26 ` David Arendt
[not found] ` <49FD6359.1020405-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-03 9:44 ` Ryusuke Konishi
[not found] ` <20090503.184449.53062216.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-03 10:06 ` David Arendt
2009-05-04 4:16 ` David Arendt [this message]
[not found] ` <49FE6C18.3050707-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 11:23 ` Ryusuke Konishi
-- strict thread matches above, loose matches on Subject: below --
2009-05-05 15:26 admin-/LHdS3kC8BfYtjvyW6yDsg
[not found] ` <D6LvKjCkn1gF.D60GTY3Z-GG6YVgmNXeLOQU1ULcgDhA@public.gmane.org>
2009-05-05 15:46 ` Ryusuke Konishi
[not found] ` <20090506.004648.105122016.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-05 16:51 ` David Arendt
[not found] ` <4A006EAB.6000206-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 19:32 ` David Arendt
[not found] ` <4A00944B.2020105-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-05 21:19 ` David Arendt
2009-05-06 3:02 ` Ryusuke Konishi
[not found] ` <20090506.120204.27533580.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-06 15:46 ` David Arendt
[not found] ` <4A01B0D2.6030509-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-10 5:43 ` Ryusuke Konishi
[not found] ` <20090510.144313.10164669.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-10 13:04 ` David Arendt
[not found] ` <4A06D0C4.5030008-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-10 15:40 ` Ryusuke Konishi
[not found] ` <20090511.004002.32775441.ryusuke-sG5X7nlA6pw@public.gmane.org>
2009-05-10 16:12 ` David Arendt
[not found] ` <4A06FCEB.7030800-/LHdS3kC8BfYtjvyW6yDsg@public.gmane.org>
2009-05-11 0:57 ` Ryusuke Konishi
2009-05-10 9:10 ` Ryusuke Konishi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=49FE6C18.3050707@prnet.org \
--to=admin-/lhds3kc8bfytjvyw6ydsg@public.gmane.org \
--cc=users-JrjvKiOkagjYtjvyW6yDsg@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.