Re: [PATCH] sky2: Don't try to turn led off in sky2_down()

[Mike McCormack <mikem@ring3k.org>]

Stephen Hemminger wrote:
> On Sat, 29 Aug 2009 22:10:33 +0900
> Mike McCormack <mikem@ring3k.org> wrote:
> 
>> There are a few problems with the following line of code in sky2_down()
>>
>>      sky2_write16(hw, B0_Y2LED, LED_STAT_OFF);
>>
>>  * It doesn't specify which port's LED to turn off.
>>  * We don't turn send LED_STAT_ON on in sky2_up()
>>  * B0_LED is 0x0006 in the vendor driver, but 0x0005 in sky2.
>>    B0_LED is right next to B0_POWER_CTRL, so this is possibly
>>    accounts for the device being accidently powered down as
>>    reported by Rene Mayrhofer.
> 
> I would rather just change the definition of B0_LED to the correct value.

How does that address the first problem?  If there are two ports, which port's LED are we turning off?

thanks,

Mike