Re: ext4_fiemap gives 0 extents for files smaller than a block (patch included)

[Surbhi Palande <surbhi.palande@canonical.com>]

Leonard Michlmayr wrote:
> Thank you for your reply.
> 
>>> @@ -3700,7 +3701,8 @@
>>>  		start_blk = start >> inode->i_sb->s_blocksize_bits;
>>> -		len_blks = len >> inode->i_sb->s_blocksize_bits;
>>> +		end_blk = (start + len - 1) >> inode->i_sb->s_blocksize_bits;
>>> +		len_blks = end_blk - start_blk + 1;
>> I don't think this is quite correct either.  For example, if blocksize  
>> is 1024
>> and start is 1023 (start_blk = 0) and len is 2 (end = 1024, end_blk =  
>> 1) then
>> len_blks = 2 which is too much.
> 
> I think that len_blks = 2 is the correct value, because the requested
> region extends into 2 blocks (namely 0 and 1). If both blocks are in two
> separate extents, then ext4_ext_walk_space should report 2 extents. (If
> it's the same extent, only 1 will be reported anyways)
> 
>> I think the right calculation here is:
>>
>>                    end_blk = (start + len + inode->i_sb->s_blocksize - 1) >>
>>                              inode->i_sb->s_blocksize_bits;
>>                    len_blks = end_blk - start_blk;
>>
> 
> This is exactly the same (provided that len > 0). You can convince
> yourself easily that ((blocksize + x) >> blocksize_bits == x >>
> blocksize_bits + 1) for any positive x, because the lower bits of
> blocksize are all 0. (Your calculation would handle the case len == 0
> right, if that was allowed.)
> 
> Regards
> Leonard

I was wondering if there is any update on the status of this patch.
Thanks !

Warm Regards,
Surbhi.