From: Michal Simek <monstr@monstr.eu>
To: Greg Kroah-Hartman <gregkh@suse.de>
Cc: linux-kernel@vger.kernel.org, David Miller <davem@davemloft.net>
Subject: Re: [PATCH 3/7] uartlite: Fix build on sparc.
Date: Fri, 26 Mar 2010 15:31:02 +0100 [thread overview]
Message-ID: <4BACC526.7090109@monstr.eu> (raw)
In-Reply-To: <1269011916-8836-3-git-send-email-gregkh@suse.de>
Greg Kroah-Hartman wrote:
> From: David Miller <davem@davemloft.net>
>
> We can get this driver enabled via MFD_TIMBERDALE which only
> requires GPIO to be on.
>
> But the of_address_to_resource() function is only present on
> powerpc and microblaze, so we have to conditionalize the
> CONFIG_OF probing bits on that.
>
> Signed-off-by: David S. Miller <davem@davemloft.net>
> Acked-by: Grant Likely <grant.likely@secretlab.ca>
> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
> ---
> drivers/serial/uartlite.c | 10 +++++-----
> 1 files changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/serial/uartlite.c b/drivers/serial/uartlite.c
> index ab2ab3c..f0a6c61 100644
> --- a/drivers/serial/uartlite.c
> +++ b/drivers/serial/uartlite.c
> @@ -19,7 +19,7 @@
> #include <linux/interrupt.h>
> #include <linux/init.h>
> #include <asm/io.h>
> -#if defined(CONFIG_OF)
> +#if defined(CONFIG_OF) && (defined(CONFIG_PPC32) || defined(CONFIG_MICROBLAZE))
What about do this in Kconfig?
Michal
> #include <linux/of.h>
> #include <linux/of_device.h>
> #include <linux/of_platform.h>
> @@ -581,7 +581,7 @@ static struct platform_driver ulite_platform_driver = {
> /* ---------------------------------------------------------------------
> * OF bus bindings
> */
> -#if defined(CONFIG_OF)
> +#if defined(CONFIG_OF) && (defined(CONFIG_PPC32) || defined(CONFIG_MICROBLAZE))
> static int __devinit
> ulite_of_probe(struct of_device *op, const struct of_device_id *match)
> {
> @@ -631,11 +631,11 @@ static inline void __exit ulite_of_unregister(void)
> {
> of_unregister_platform_driver(&ulite_of_driver);
> }
> -#else /* CONFIG_OF */
> -/* CONFIG_OF not enabled; do nothing helpers */
> +#else /* CONFIG_OF && (CONFIG_PPC32 || CONFIG_MICROBLAZE) */
> +/* Appropriate config not enabled; do nothing helpers */
> static inline int __init ulite_of_register(void) { return 0; }
> static inline void __exit ulite_of_unregister(void) { }
> -#endif /* CONFIG_OF */
> +#endif /* CONFIG_OF && (CONFIG_PPC32 || CONFIG_MICROBLAZE) */
>
> /* ---------------------------------------------------------------------
> * Module setup/teardown
--
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian
next prev parent reply other threads:[~2010-03-26 14:31 UTC|newest]
Thread overview: 54+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-03-19 15:13 [GIT PATCH] TTY fixes for 2.6.34-git Greg KH
2010-03-19 15:18 ` [PATCH 1/7] Revert "tty: Add a new VT mode which is like VT_PROCESS but doesn't require a VT_RELDISP ioctl call" Greg Kroah-Hartman
2010-03-19 15:18 ` [PATCH 2/7] tty: Take a 256 byte padding into account when buffering below sub-page units Greg Kroah-Hartman
2010-03-19 15:18 ` [PATCH 3/7] uartlite: Fix build on sparc Greg Kroah-Hartman
2010-03-19 16:15 ` Grant Likely
2010-03-19 16:26 ` Grant Likely
2010-03-26 14:31 ` Michal Simek [this message]
2010-03-19 15:18 ` [PATCH 4/7] hvc_console: Fix race between hvc_close and hvc_remove Greg Kroah-Hartman
2010-03-19 15:18 ` Greg Kroah-Hartman
2010-03-20 21:04 ` Benjamin Herrenschmidt
2010-03-20 21:04 ` Benjamin Herrenschmidt
2010-03-21 4:37 ` Amit Shah
2010-03-21 4:37 ` Amit Shah
2010-03-24 12:19 ` Amit Shah
2010-03-24 12:19 ` Amit Shah
2010-03-25 23:30 ` Anton Blanchard
2010-03-25 23:30 ` Anton Blanchard
2010-03-26 2:01 ` Amit Shah
2010-03-26 2:01 ` Amit Shah
2010-03-26 9:13 ` Sachin Sant
2010-03-26 9:13 ` Sachin Sant
2010-03-26 9:58 ` Amit Shah
2010-03-26 9:58 ` Amit Shah
2010-03-26 10:54 ` Stephen Rothwell
2010-03-26 10:54 ` Stephen Rothwell
2010-03-26 11:42 ` Sachin Sant
2010-03-26 11:42 ` Sachin Sant
2010-03-26 11:52 ` Alan Cox
2010-03-26 11:52 ` Alan Cox
2010-03-26 12:49 ` Amit Shah
2010-03-26 12:49 ` Amit Shah
2010-03-26 12:43 ` Amit Shah
2010-03-26 12:43 ` Amit Shah
2010-04-06 11:42 ` Anton Blanchard
2010-04-06 11:42 ` Anton Blanchard
2010-04-06 12:09 ` Amit Shah
2010-04-06 12:09 ` Amit Shah
2010-04-06 12:27 ` Sachin Sant
2010-04-06 12:27 ` Sachin Sant
2010-04-06 12:32 ` Alan Cox
2010-04-06 12:32 ` Alan Cox
2010-04-08 0:26 ` Rusty Russell
2010-04-08 0:26 ` Rusty Russell
2010-03-24 10:45 ` Benjamin Herrenschmidt
2010-03-24 10:45 ` Benjamin Herrenschmidt
2010-03-24 10:57 ` Amit Shah
2010-03-24 10:57 ` Amit Shah
2010-03-24 11:37 ` Alan Cox
2010-03-24 11:37 ` Alan Cox
2010-03-24 15:05 ` Amit Shah
2010-03-24 15:05 ` Amit Shah
2010-03-19 15:18 ` [PATCH 5/7] tty_buffer: Fix distinct type warning Greg Kroah-Hartman
2010-03-19 15:18 ` [PATCH 6/7] tty: cpm_uart: use resource_size() Greg Kroah-Hartman
2010-03-19 15:18 ` [PATCH 7/7] tty_port,usb-console: Fix usb serial console open/close regression Greg Kroah-Hartman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4BACC526.7090109@monstr.eu \
--to=monstr@monstr.eu \
--cc=davem@davemloft.net \
--cc=gregkh@suse.de \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.