Chikkature Rajashekar, Madhusudhan had written, on 04/06/2010 06:23 PM, 
the following:
> 
>> -----Original Message-----
>> From: Felipe Balbi [mailto:felipe.balbi@nokia.com]
>> Sent: Tuesday, April 06, 2010 11:57 AM
>> To: ext Nishanth Menon
>> Cc: Balbi Felipe (Nokia-D/Helsinki); Chikkature Rajashekar, Madhusudhan;
>> me@felipebalbi.com; 'kishore kadiyala'; 'Vimal Singh'; tony@atomide.com;
>> S, Venkatraman; linux-omap@vger.kernel.org; linux-kernel@vger.kernel.org;
>> Lavinen Jarkko (Nokia-D/Helsinki)
>> Subject: Re: [PATCH v3] OMAP: Fix for bus width which improves SD card's
>> peformance.
>>
>> On Tue, Apr 06, 2010 at 06:55:03PM +0200, ext Nishanth Menon wrote:
>>> some reasons why i love switch statements ;) since I dont expect other
>>> than precisely 4 and 8 (do we expect 5,6,7 - i might be wrong).. but if
>>> it is so, wont the following be better?
>>>
>>> switch (mmc_slot(host).wires)
>>> {
>>> case 8:
>>> 	mmc->caps |= MMC_CAP_8_BIT_DATA;
>>> 	/* fall thru*/
>>> case 4:
>>> 	mmc->caps |= MMC_CAP_4_BIT_DATA;
>>> 		break;
>>> default:
>>> 	WARN("bad width");
>>> }
>> I like that, but I remember Madhu (or someone else) saying he thinks
>> it's less readable this way. Go figure...
>>
> Well, I did not comment on the usage of switch here. Note we only need to
> handle 8-bit and 4-bit.The board files need not setup 8-bit or 4-bit if the
> configuration of that board is 1-bit. The driver will still work in 1-bit
> mode which would mean there is nothing to do in default case and should not
> err out.
check the attachment out.. hope that takes care of it.. just as a 
reference alone ofcourse..
-- 
Regards,
Nishanth Menon