[U-Boot] [PATCH v3 00/19] SPEAr : Network support for spear platforms and SPEAr1300

[Vipin KUMAR <vipin.kumar@st.com>]

Dear Tom,

I am still waiting for Ack/feedback if any on this patchset v3
All feedbacks provided by you on patchset v2 have been incorporated

Regards
Vipin

On 5/9/2010 7:46 PM, Vipin Kumar wrote:
> Hello Tom,
> 
> Please consider this patch-set for mainline submission.
> Please let me know if there are any changes to be made
> in code or if the patches are good to go into mainline
> 
> Thanks & Regards
> Vipin
> 
> On Thu, May 6, 2010 at 4:48 PM, Vipin KUMAR <vipin.kumar@st.com> wrote:
>> Hello Tom,
>>   The following patch-set contains all the accepted feedbacks on patch-set v2.
>>   Please consider this for submission into mainline
>>
>>   Below changes are introduced other than the recieved review comments
>>   1. Introduced a CONFIG_DW_SEARCH_PHY definition, which if defined searches
>>   the ethernet phy address. Searching was always enabled in earlier patch
>>   2. Introduced a new function dw_write_hwaddr in ethernet driver and
>>   registered it as a callback via dev->write_hwaddr. This is a new feature
>>   recently implemented by Ben.
>>
>> Thanks in advance
>>
>> Regards
>> Vipin
>>
>> Vipin Kumar (19):
>>  u-boot.img file not created when srctree and objtree are different
>>  change_bit routine defined
>>  SPEAr : SMI erase and write timeouts increased
>>  SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>>  SPEAr : Reducing the max RAM size to 128MB
>>  SPEAr : Basic arch related support added for SPEAr SoCs
>>  SPEAr : Network driver support added
>>  SPEAr : Network support configured for spear SoCs
>>  SPEAr : macb driver support added for spear310 and spear320
>>  SPEAr : FSMC driver support added
>>  SPEAr : Configuring FSMC driver for NAND interface
>>  SPEAr : i2c driver moved completely into drivers/i2c
>>  SPEAr : smi driver moved completely into drivers/mtd
>>  SPEAr : USB Device Controller driver support added
>>  SPEAr : Supporting various configurations for spear3xx and spear6xx
>>    boards
>>  SPEAr : Basic spear1300 architecture support added
>>  SPEAr : spear1300 SoC support added
>>  SPEAr : Removing extraneous code
>>  SPEAr : USB device controller bugfixes
>>
>>  MAINTAINERS                                        |    1 +
>>  MAKEALL                                            |    1 +
>>  Makefile                                           |   30 +-
>>  arch/arm/cpu/arm926ejs/spear/Makefile              |    3 +-
>>  arch/arm/cpu/arm926ejs/spear/cpu.c                 |   78 +++
>>  arch/arm/cpu/arm_cortexa8/spear13xx/Makefile       |   52 ++
>>  arch/arm/cpu/arm_cortexa8/spear13xx/cache.S        |  114 +++++
>>  arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c          |   96 ++++
>>  .../arm_cortexa8/spear13xx/reset.c}                |   52 +--
>>  arch/arm/cpu/arm_cortexa8/spear13xx/timer.c        |  138 +++++
>>  .../arm/include/asm/arch-spear/clk.h               |   26 +-
>>  arch/arm/include/asm/arch-spear/hardware.h         |   16 +-
>>  arch/arm/include/asm/arch-spear/spr_misc.h         |    5 +
>>  .../arm/include/asm/arch-spear13xx/hardware.h      |   33 +-
>>  arch/arm/include/asm/arch-spear13xx/spr_gpt.h      |   85 ++++
>>  arch/arm/include/asm/arch-spear13xx/spr_misc.h     |  317 ++++++++++++
>>  .../arm/include/asm/arch-spear13xx/sys_proto.h     |   29 +-
>>  arch/arm/include/asm/bitops.h                      |   11 +-
>>  board/spear/common/Makefile                        |   10 +-
>>  board/spear/common/spr_misc.c                      |   28 +-
>>  board/spear/spear1300/Makefile                     |   51 ++
>>  board/spear/spear1300/config.mk                    |   28 +
>>  board/spear/spear1300/spear1300.c                  |   88 ++++
>>  .../spear/spear1300/spr_lowlevel_init.S            |   35 +-
>>  board/spear/spear300/config.mk                     |   11 -
>>  board/spear/spear300/spear300.c                    |   15 +-
>>  board/spear/spear310/config.mk                     |   11 -
>>  board/spear/spear310/spear310.c                    |   36 ++-
>>  board/spear/spear320/config.mk                     |   11 -
>>  board/spear/spear320/spear320.c                    |   23 +-
>>  board/spear/spear600/config.mk                     |   11 -
>>  board/spear/spear600/spear600.c                    |   15 +-
>>  doc/README.designware_eth                          |   25 +
>>  doc/README.spear                                   |   46 ++-
>>  drivers/i2c/Makefile                               |    2 +-
>>  drivers/i2c/{spr_i2c.c => designware_i2c.c}        |    4 +-
>>  .../spr_i2c.h => drivers/i2c/designware_i2c.h      |    6 +-
>>  drivers/mtd/Makefile                               |    2 +-
>>  drivers/mtd/nand/Makefile                          |    2 +-
>>  drivers/mtd/nand/fsmc_nand.c                       |  366 ++++++++++++++
>>  drivers/mtd/nand/spr_nand.c                        |  124 -----
>>  drivers/mtd/{spr_smi.c => st_smi.c}                |   59 ++-
>>  .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h   |    8 +-
>>  drivers/net/Makefile                               |    1 +
>>  drivers/net/designware.c                           |  531 ++++++++++++++++++++
>>  drivers/net/designware.h                           |  264 ++++++++++
>>  drivers/serial/usbtty.h                            |    4 +-
>>  drivers/usb/gadget/Makefile                        |    2 +-
>>  drivers/usb/gadget/{spr_udc.c => designware_udc.c} |  116 +++--
>>  include/configs/spear-common.h                     |   33 +-
>>  include/configs/spear13xx_evb.h                    |  202 ++++++++
>>  include/configs/{spear3xx.h => spear3xx_evb.h}     |   30 ++
>>  include/configs/{spear6xx.h => spear6xx_evb.h}     |   13 +
>>  include/linux/mtd/fsmc_nand.h                      |  104 ++++
>>  include/netdev.h                                   |    1 +
>>  include/usb/{spr_udc.h => designware_udc.h}        |    6 +-
>>  56 files changed, 2993 insertions(+), 418 deletions(-)
>>  create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>>  rename arch/arm/{include/asm/arch-spear/spr_nand.h => cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>>  mode change 100644 => 100755
>>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h (64%)
>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>>  create mode 100644 board/spear/spear1300/Makefile
>>  create mode 100644 board/spear/spear1300/config.mk
>>  create mode 100644 board/spear/spear1300/spear1300.c
>>  copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S (56%)
>>  create mode 100644 doc/README.designware_eth
>>  rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>>  rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
>>  create mode 100644 drivers/mtd/nand/fsmc_nand.c
>>  delete mode 100644 drivers/mtd/nand/spr_nand.c
>>  rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>>  rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h (96%)
>>  create mode 100644 drivers/net/designware.c
>>  create mode 100644 drivers/net/designware.h
>>  rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>>  create mode 100644 include/configs/spear13xx_evb.h
>>  rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>>  rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>>  create mode 100644 include/linux/mtd/fsmc_nand.h
>>  rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>>
>> _______________________________________________
>> U-Boot mailing list
>> U-Boot at lists.denx.de
>> http://lists.denx.de/mailman/listinfo/u-boot
>>
>