[PATCH v2] davinci: Add MityDSP-L138/MityARM-1808 SOM support

[michael.williamson@criticallink.com (Michael Williamson)]

 On 7/19/2010 11:58 AM, Joe Perches wrote:
> On Mon, 2010-07-19 at 09:35 -0400, Michael Williamson wrote:
>> +        pr_warning("%s: mmcsd0 mux setup failed:" " %d\n", __func__,ret);
> Isn't this easier to read as a single string?
>
> 	pr_warning("%s: mmcsd0 mux setup failed: %d\n", __func__, ret);
>
> Also, if you want __func__ to prefix every printk you could use:
>
> #define pr_fmt(fmt) "%s: " fmt, __func__
>
> and use:
>
> 	pr_warning("mmcsd0 mux setup failed: %d\n", ret);
>

Didn't know about the pr_fmt macro.  Thanks.  I'll update / fix the double strings.


>> +    ret = da8xx_register_mmcsd0(&da850_mmc_config);
>> +    if (ret)
>> +        pr_warning("%s: mmcsd0 registration failed:", __func__, " %d\n", ret);
> Compile tested?  Perhaps you mean:
>
> 	pr_warning("%s: mmcsd0 registration failed: %d\n", __func__, ret);
>
> []
>

I did recompile and re-test, but missed the compiler warnings when I built the changes.  They were there.  I will correct.

>> +    pr_info("EMAC = %02X:%02X:%02X:%02X:%02X:%02X\n",
>> +        peripheral_config.ENETConfig.MACAddr[0],
>> +        peripheral_config.ENETConfig.MACAddr[1],
>> +        peripheral_config.ENETConfig.MACAddr[2],
>> +        peripheral_config.ENETConfig.MACAddr[3],
>> +        peripheral_config.ENETConfig.MACAddr[4],
>> +        peripheral_config.ENETConfig.MACAddr[5]);
> There's are extensions to printk/vsnprintf that is used for
> various things like MAC and IP addresses. (see: lib/vsprintf.c)
>
> This should be:
>
> 	pr_info("EMAC = %pM\n", peripheral_config.ENETConfig.MACAddr);
>
>
>

OK.  Much easier to read.  Appreciate the help.  I'll go round again and try to be a bit more careful prior to resubmitting.

-Mike