[U-Boot] [PATCH] Use common function to set GPIOs for MX3 and MX5

[Stefano Babic <sbabic@denx.de>]

David Jander wrote:
> Hi Stefano,
> 

Hi David,

> I just checked in the reference manual of the i.MX31, and there the meaning of 
> this bit has the same polarity as on the i.MX51, so you'll need to fix this 
> also at the end of the spi_setup_slave() function, in the #else path of the 
> #ifdef CONFIG_MX51 directive.
> 
> if (!(mode & SPI_CPOL))
> 	ctrl_reg |= MXC_CSPICTRL_POL;
> 
> should be:
> 
> if (mode & SPI_CPOL)
> 	ctrl_reg |= MXC_CSPICTRL_POL;
> 
> Would be nice if someone with a MX31 board could verify this.

I can test myself on a qong board - I hope someone else can test on
other MX.31 boards.

> I agree, and I guess you can better include it in your patch-set, otherwise 
> I'd have to wait for your patches and then provide my own patch on top of 
> that.... too complicated :-)

I will do it - I think I could send in a short time the whole patchset
for review :-).

> 
> I am also adding support for S25FL032P chips to the spansion driver. Will post 
> a patch later.

I have seen. However, it should be better if you send the patch also to
the maintainer for the MTD subsystem (Stefan Roese, I set his address in
CC).

> Right now I have correct detection of the chip, but the environment is not 
> saved and read back correctly. Still investigating... maybe some chip 
> configuration prolem in the spansion driver?

Probably. I have got some issues with the ST that do not depend from the
modifications in SPI driver.

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================