hi
under ubuntu 10.04LTS
on dell vostro 3500
Intel Corporation 5 Series/3400 Series Chipset SMBus Controller
[8086:3b30] (rev 06)
By default i2c-i801 is in blacklist.conf
if i remove from blacklist here it is dmesg
i801_smbus 0000:00:1f.3: PCI INT C -> GSI 18 (level, low) -> IRQ
18
[ 14.801179] ACPI: resource 0000:00:1f.3 [0xf000-0xf01f] conflicts
with ACPI region SMBI [0xf000-0xf00f]
[ 14.801182] ACPI: If an ACPI driver is available for this device,
you should use it instead of the native driver
where SMBI is in DSDT_DELL_WN09.dsl
OperationRegion (SMBI, SystemIO, ShiftLeft (SBAR,
0x05), 0x10)
Field (SMBI, ByteAcc, NoLock, Preserve)
{
HSTS, 8,
Offset (0x02),
HCON, 8,
HCOM, 8,
TXSA, 8,
DAT0, 8,
DAT1, 8,
HBDR, 8,
PECR, 8,
RXSA, 8,
SDAT, 16
}
lspci -vvnnxxxx
00:1f.3 SMBus [0c05]: Intel Corporation 5 Series/3400 Series Chipset
SMBus Controller [8086:3b30] (rev 06)
Subsystem: Dell Device [1028:0441]
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin C routed to IRQ 18
Region 0: Memory at fbc05000 (64-bit, non-prefetchable) [size=256]
Region 4: I/O ports at f000 [size=32]
Kernel modules: i2c-i801
00: 86 80 30 3b 03 00 80 02 06 00 05 0c 00 00 00 00
10: 04 50 c0 fb 00 00 00 00 00 00 00 00 00 00 00 00
20: 01 f0 00 00 00 00 00 00 00 00 00 00 28 10 41 04
30: 00 00 00 00 00 00 00 00 00 00 00 00 03 03 00 00
finaly, with or without i2c-i801 and//or k8temp load at startup
sensors return only
fidit@de100816A:~$ sensors
acpitz-virtual-0
Adapter: Virtual device
temp1: +39.5°C (crit = +100.0°C)
under everest on seven, 6 temp are detect.