[U-Boot] [PATCH v6 1/1] imx: Get fec mac address from fuse

[Stefano Babic <sbabic@denx.de>]

On 11/19/2010 07:44 AM, Jason Liu wrote:
>> I think you are right. I did not have the mx27 board to do test.
>> Thanks for test.
>>
>> I only test it on mx51babbage board, the following is the output:
>>
>> Net:   got MAC address from fuse: 00:04:9f:00:f7:78
>> which is the same as the MAC address programmed on the board.
> 
> 
> Do you have any other comments about this patch?

As I have not seen any other comments in the ML, I have tried to apply
the patch and to test myself. From my point of view we have to be sure
that the patch is working for all supported processors, and I can test
it for i.MX27. As you already test it on i.MX51, can you test it on
i.MX25 ? Or at least check with tracing if the address is correct for
this processor, too ?

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================