Hi,

On 08/01/11 19:54, Guenter Roeck wrote:
> couple of comments below.

Thanks again for your suggestions! I'm attaching the latest version with
your ideas included.

>> +The PO output pin is always active-low.
> 
> What is the point of configuring PO1 if you set PO2 such that PO is always low ?

Maybe the above was a bit misleading, though correct: "always
active-low" wasn't intended to mean "always low", but instead "low when
active". :-) Nevertheless, I clarified it. ("The PO output pin of the
DS620 operates active-low.").

Thanks,

Roland