[U-Boot] [PATCH 2/2] iMX5: EfikaMX: Work-in-progress board support

[Stefano Babic <sbabic@denx.de>]

On 01/13/2011 06:15 PM, Marek Vasut wrote:

>>> +	mxc_request_iomux(MX51_PIN_NANDF_RB3, IOMUX_CONFIG_GPIO);
>>> +	mxc_iomux_set_pad(MX51_PIN_NANDF_RB3, PAD_CTL_100K_PU);
>>> +	mxc_gpio_direction(IOMUX_TO_GPIO(MX51_PIN_NANDF_RB3),
>>> MXC_GPIO_DIRECTION_IN); +	rev |=
>>> (!!mxc_gpio_get(IOMUX_TO_GPIO(MX51_PIN_NANDF_RB3))) << 2;
>>
>> Is it ok to leave the NAND pins configured as GPIO, or should they set
>> back for the NFC controller ?
> 
> I don't think there is even NAND used on efikamx. Though I might be mistaken.

Understood, then I agree to leave the iomux set with gpios.

>>
>> Replace fix constants with defines, adding them to mc13892.h if they are
>> missing.
> 
> Is any sane datasheet for this thing available ? If so, can you link me to it 
> please?

There is a datasheet, I do not know if you can consider it "sane" ;-)

http://cache.freescale.com/files/analog/doc/data_sheet/MC13892.pdf?fpsp=1

The register description is quite spread in the manual. You can see the
complete SPI Bitmap on pages 118-121.

I have already set most constants in include/mc13892.h, probably there
are some missing.

>>> +#define	__io
>>
>> I think we have already discussed abot this define. Should it not move
>> to another file, such as imx-regs.h ? Or is there a better solution ?
> 
> The thread where we discussed this got deaf. I tried asking further, but no 
> reply :-(

Agree, I remember the issue, I do not remember any decision. Anyway, I
think the position of this macro is wrong. It is related to the
processor, that can have it or not, and it is not related to the board.
I see that in u-boot __io is defined in board configuration file, but I
do not think it is correct.

At least I will suggest to move this define in the processor related
file (-->imx-regs.h).

Cheers,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================