Re: fsl-esdhc on P2020 weird endianess behavior

["tiejun.chen" <tiejun.chen@windriver.com>]

Elie De Brauwer wrote:
> Hello list,
> 
> I have a P2020 processor on a custom board which uses the embedded
> fsl-esdhc controller. Hardware-wise this is functional and in u-boot
> everything seems to behave (mmc part 0 gives the correct partition table
> and ext2ls/fatls are capable of reading the contents of the sd card).
> 
> However as soon as I start Linux (2.6.36), I get all sorts of unwanted
> behavior. Linux is unable to detect the partition layout (but if I do a

Can you re-partition that under Linux? i.e, you can use fdisk to do this. Then
I'm a bit curious what it'll be happened.

> hexdump of the MBR, I see the endianness is swapped (last 4 bytes are aa
> 55 00 00). Also when I try to obtain the card registers they show the
> same behavior:
> # cat ./devices/soc.0/ff72e000.sdhci/mmc_host/mmc0/mmc0:0001/scr
> 0000b50200000000
> 
> While for comparison the same value on my (x86) laptop gives:
> edb@lapedb:/sys/devices/pci0000:00/0000:00:1e.0/0000:15:00.2/mmc_host/mmc0/mmc0:0001$
> cat scr
> 02b5000000000000
> 
> In my config I have the following set:
> CONFIG_MMC_SDHCI=y
> CONFIG_MMC_SDHCI_IO_ACCESSORS=y
> CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER=y
> # CONFIG_MMC_SDHCI_PCI is not set
> CONFIG_MMC_SDHCI_OF=y
> CONFIG_MMC_SDHCI_OF_ESDHC=y

At least looks the config is fine.

Tiejun

> 
> 
> any pointers are welcome.
> 
> gr
> E.
>