Re: [Bridge] Bridge suddenly only passes traffic if in promiscuous mode

[Ben Greear <greearb@candelatech.com>]

On 02/08/2011 11:29 AM, Jeff Mitchell wrote:
> Hello,
>
> I have a bridge to various interfaces. There is an IP address on the
> bridge, and hosts on the interfaces connected to the bridge use the
> bridge's IP address as a gateway. STP is off and the forwarding delay is
> set to 0.
>
> This has been working fine, however, today I needed to change around
> some IPv6 addresses on the connected hosts. I made the IPv6 changes and
> rebooted those boxes, only to find that suddenly no traffic -- IPv4 *or*
> IPv6 -- was passing through the bridge.
>
> When I pulled up tshark to see what was going on, traffic suddenly
> started flowing again. And even as I type this, as long as tshark is
> running on that interface (no matter what the capture filter is),
> traffic is flowing. The moment I stop tshark from running, traffic
> stops. IOW, the bridge is only passing traffic while in promiscuous mode.
>
> I didn't change the IP address on the bridge itself. As far as I can
> tell I didn't do anything odd whatsoever. But I have no idea what's
> causing this and I'd really like to not reboot the box if at all possible.
>
> Does anyone have any idea what might be causing this and/or how to
> troubleshoot this?

What kernel version?

And, you are sniffing the physical interface, or the bridge?

Maybe send us output of brctl show, and ifconfig -a?

Promisc bit is sometimes hard to detect properly, so if you can, please
post /sys/class/net/[iface-name]/flags
If bit 0x100 is set, the NIC is actually promisc, regardless of what
ifconfig -a shows.

Thanks,
Ben

>
> Thanks,
> Jeff
> _______________________________________________
> Bridge mailing list
> Bridge@lists.linux-foundation.org
> https://lists.linux-foundation.org/mailman/listinfo/bridge


-- 
Ben Greear <greearb@candelatech.com>
Candela Technologies Inc  http://www.candelatech.com