Re: Booting BeagleBoard

[Gary Thomas <gary@mlbassoc.com>]

On 02/13/2011 08:21 AM, Koen Kooi wrote:
>
> Op 13 feb 2011, om 16:06 heeft Gary Thomas het volgende geschreven:
>
>> On 02/13/2011 08:00 AM, Koen Kooi wrote:
>>>
>>> Op 13 feb 2011, om 15:57 heeft Gary Thomas het volgende geschreven:
>>>
>>>> On 02/12/2011 08:01 AM, Koen Kooi wrote:
>>>>>
>>>>> Op 12 feb 2011, om 15:52 heeft Gary Thomas het volgende geschreven:
>>>>>
>>>>>> I have a BeagleBoard C3 (not the new xM).  Trying to run the
>>>>>> latest Poky ran into some problems:
>>>>>>
>>>>>> * The boot commands in README.hardware are no longer accurate
>>>>>>   for the 2.6.37 (linux-yocto) kernel.  At least you need to
>>>>>>   use ttyO2 for the serial console.
>>>>>> * There is no video?  /dev/fb0 is not being created.
>>>>>>
>>>>>> I know that the previous (Angstrom based) 2.6.32 kernel had
>>>>>> lots of additions which support video (DSS subsystem) and
>>>>>> also camera (ISP).  Has this support been ported forward
>>>>>> into the Yocto kernel?
>>>>>
>>>>> Even better, there is a proper BSP with beagleboard support: http://gitorious.org/angstrom/angstrom-layers/commits/master
>>>>
>>>> How is this used?  I tried just adding a pointer to that tree
>>>> in my conf/bblayers.conf.  I also tried moving that tree into
>>>> my poky sources at the same level as meta-emenlow, etc.  Both
>>>> attempts immediately yielded this error:
>>>>   ERROR: Unable to parse conf/bitbake.conf: Could not include required file conf/machine/include/omap3.inc
>>>>
>>>> Perhaps you can give some guidance for how to use this?
>>>
>>> http://thread.gmane.org/gmane.linux.distributions.angstrom.devel/4698/focus=4700
>>
>> Obviously this is not what I'm looking for.
>>
>> What I had wanted to test was your layering on top of my extant
>> Poky/Yocto environment.  I don't want to start over as I have my
>> own layers that work just fine with Poky.
>
> I obviously misunderstood your request on the angstrom mailinglist on how to setup angstrom on top of yocto as a request on how to setup angstrom on top of yocto. I'm sorry that I fail to understand such obvious things. I will from now on stop trying to understand your requests to avoid any confusion and perceived wrongdoing on my part.

That would be reasonable except that this entire thread was on
the Poky mailing list :-)  If you look closely, I asked about
running the BeagleBoard on the latest Poky/Yocto and you replied
with this info about your angstrom layers.

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------