Re: Question about your DSP topic branch

[Patrick Lai <plai@codeaurora.org>]

Hi Liam/Mark,

In the back-end platform driver, routing table and array of widgets are 
defined to describe interconnection of front-end and back-end. Instead 
of defining FE and BE as AIF pin using SND_SOC_DAPM_AIF_IN/OUT macros,
I would like to use SND_SOC_DAPM_AIF_IN_E/OUT_E macros. Essentially, I 
want to register event handler to jump start routing in the DSP for a 
newly activated FE under multiple streams to single HW path scenario. At 
this time, BE is already activated so I need other mechanism to jump 
start routing. I could put the logic in my front-end CPU DAI driver. 
However, I feel that path setup should be handled by DAPM/DSP framework. 
Hence, I am looking for a good place to trigger calling of event handler 
in soc-dapm.c/soc-dsp.c. Any suggestion?

Thanks
Patrick

-- 
Sent by an employee of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.